TREVIDEA G3 Ferrari G50046 Manual Del Usuario página 11

7 Motor unit fixing knob
10 Fixing ring
13 Drive shaft
16 Fan stopper
19 Button OSC
22 Button SPEED
25 Light Mode
ASSEMBLING
The fan motor can work even if the protective grids have not yet been assembled and fixed. To ensure the
maximum safety, perform the installation completely before operating.
1) Place the lower tube (11) at the center of the base (18). Turn the base upside down and place the ring (10),
then insert the screw (12) in the ring and screw to link the tube and the base.
2) Unscrew the height adjustment knob (9), take out the upper tube (8) from lower tube (11) to the desired
length and secure by tightening the knob (9). Insert the motor unit into the upper tube (8) and tighten the
locking knob of the motor housing (7) to lock both sides.
3) Place the rear grid (3) near the plastic of motor (4) with metal handle facing upwards. Fit the holes placed
in the central part of grid with the pins in plastic protection (4) and secure the parts with the stopper (15).
4) Insert the fan (2) in the drive shaft (13) and thread the stopper (16) to the threaded end of the crankshaft.
5) Remove the fixing screw (17). Place the front grid (1) in front of rear grid (3) matching holes on the grids.
6) Close the locking pins and fasten the two grids tightening the securing screw (17) previously removed. The
fan is now correctly assembled.
OPERATING
Once finished assembling the unit, place the fan following the safety instructions, then plug it to the electrical
outlet. The control panel (14) and the remote control (5) operate the various functions of the fan.
Press button ON/OFF (23). The fan switches on.
Press the button SPEED (22) to adjust the wind power different speeds.
L: low speed
OSCILLATION
activated by pressing the button OSC (19). Push again to disable the oscillation.
TIMER
The fan is equipped with a 7.5 hours timer. Press button TIMER (21) if you want the appliance
to turn off after a certain period of time (between 30 minutes and 7.5 hours). Press once to set it off after 30
minutes, twice to set 1 hour, 3 times for 2 hours, and so on up to 7.5 hours. The sum of the times associated to
the switched on lights (26) indicate the time set for the timer.
NATURAL AND SLEEP MODE
Pressing one time the button MODE (20) the fan enters in NATURAL mode and the light (25) switches on.
In this mode the fan reproduces the natural breath of the wind, according to some preset cycles.
Pressing again the button MODE (20) the fan enters in SLEEP mode and the light (25) switches off. This
function is ideal during the night, for better comfort during sleep. The ventilation cycles are preset
REMOTE CONTROL
Open the cover on the back of the remote control and insert 1 battery 3V type CR2032 or CR2025 following
the correct polarity (+/-). Close the battery cover before using the remote control.
- Remove the batteries if you will not use the remote for an extended period of time.
- Whatever the type of exhausted battery, it must not be thrown in the household waste, in the fire or in the
water. Exhausted battery must be recycled or disposed of in the appropriate dedicated collection centers.
8 Upper tube
11 Lower tube
14 Control panel
17 Front grid fixing screw
20 Button MODE
23 Button ON/OFF
26 Lights Timer
M: medium speed
The oscillation of the head is only possible when the fan is turned on and it can be
9 Adjusting height knob
12 Screw for the base
15 Rear grid stopper
18 Base
21 Button TIMER
24 Light oscillation
27 Lights speed
H: high speed
10