Publicidad
Idiomas disponibles
Idiomas disponibles
NOTICE! Risk of damage! Only op-
erate the function selector switch
when the tool has stopped.
Function
Drilling (Striking
mechanism OFF)
Hammer drilling
(Percussion ON)
Chisel position ad-
justment
Chiselling
On/Off switch (8)
• Switching on: Press
• Switching off: Release
LED display (10)
•
LED display (green): Tool ready
for operation
•
LED indicator (red): Carbon
brushes used up (see Troubleshooting,
p. 35)
Select tool
Notes
• For hammer drilling, you need a drill
with SDS-Plus attachment (19).
NOTICE! Risk of damage! "Hammer
drilling" mode may only be used if the
keyed chuck is not fitted!
• For chiselling, use a chisel with SDS-
Plus attachment (20).
NOTICE! When a chisel is inserted,
the machine may only be operated in
"Chiselling" mode.
• For drilling without impact in wood,
metal and plastic, use the keyed chuck
with SDS-Plus adapter (13). You can in-
sert cylindrical drills ø 1.5–13 mm into
this.
Symbol
Attaching and removing the
attachment tool
Notes
• Tool holder (1): SDS-Plus
NOTICE! Risk of damage! Only use the
keyed chuck (13) for "Drilling" mode.
• The SDS-Plus attachment tool/keyed
chuck has some radial play due to the
system. This has no effect on the accur-
acy of the hole.
• Before working, clean the attachment
tool with SDS holder and grease the in-
sertion end slightly with the grease (17)
included in the scope of delivery (0.5 -
1 g).
• Ensure the dust cap (2) is not damaged
when inserting tools. The dust cap (2)
largely prevents drilling dust from enter-
ing the tool holder during operation.
NOTICE! A damaged dust cap (2)
must be replaced immediately. It is re-
commended to have this done by a ser-
vice centre.
• Directional data viewed from behind.
Attaching the attachment tool
(SDS-Plus) (Fig. B)
1. Unlock the SDS-Plus tool holder (1):
Pull the locking sleeve (3) backwards.
2. Insert the insert tool into the SDS-Plus
tool holder (1) by turning it.
3. Clamp the attachment tool: Release the
locking sleeve (3).
4. Check that the attachment tool is firmly
secure by pulling on it.
Removing the attachment tool
(SDS-Plus) (Fig. B)
1. Unlock the SDS-Plus tool holder (1):
Pull the locking sleeve (3) backwards.
CAUTION! Risk of burn injury!
2.
Attachment tools – especially drills –
can become very hot. Wear protective
gloves whenever appropriate.
GB
MT
29
Publicidad
