Bosch 0601623000 Manual Original página 25

OBJ_BUCH-813-001.book Page 24 Tuesday, September 30, 2008 1:13 PM
24 | English
Mounting the Extraction Adapter
(see figure B)
Attach the extraction adapter 22 onto the saw-
dust ejector 14 until it latches. A vacuum hose
with a diameter of 35 mm can be connected to
the extraction adapter 22.
The extraction adapter may not be mounted
when no external dust extraction is con-
nected. Otherwise the extraction channel
can become clogged.
Do not connect a dust bag to the extraction
adapter. Otherwise the extraction system
can become clogged.
To ensure optimum extraction, the extraction
adapter 22 must be cleaned regularly.
External Dust Extraction
Connect the vacuum hose 30 to a vacuum clean-
er (accessory). An overview for connecting to
various vacuum cleaners can be found at the
end of this manual.
The machine can be plugged directly into the re-
ceptacle of a Bosch all-purpose vacuum cleaner
with remote starting control. The vacuum clean-
er starts automatically when the machine is
switched on.
The vacuum cleaner must be suitable for the ma-
terial being worked.
When vacuuming dry dust that is especially det-
rimental to health or carcinogenic, use a special
vacuum cleaner.
Operation
Operating Modes
Before any work on the machine itself, pull
the mains plug.
Adjusting the Cutting Depth (see figure C)
Adjust the cutting depth to the thickness of
the workpiece. Less than a full tooth of the
blade teeth should be visible below the work-
piece.
1 619 P06 540 | (30.9.08)
Loosen the clamping lever 23. For a smaller cut-
ting depth, pull the saw away from the base
plate 12; for a larger cutting depth, push the
saw toward the base plate 12. Adjust the de-
sired cutting depth at the cutting-depth scale.
Tighten the clamping lever 23 again.
If the cutting depth cannot be fully adjusted af-
ter loosening clamping lever 23, pull clamping
lever 23 away from the saw and swivel it down-
ward. Release the clamping lever 23 again. Re-
peat this procedure until the requested cutting
depth can be adjusted.
If the cutting depth cannot be sufficiently locked
after tightening clamping lever 23, pull clamping
lever 23 away from the saw and swivel it up-
ward. Release the clamping lever 23 again. Re-
peat this procedure until the cutting depth is
locked.
Adjusting the Cutting Angle
Loosen the wing bolts 6 and 25. Tilt the saw
sidewards. Adjust the desired measure on the
scale 5. Tighten the wing bolts 6 and 25 again.
Note: For bevel cuts, the cutting depth is small-
er than the setting indicated on the cutting-
depth scale 24.
Cutting Marks
45 0
The 0° cutting mark (9) indicates the position of
the saw blade for right-angled cuts. The 45° cut-
ting mark (8) indicates the position of the saw
blade for 45° cuts.
For precise cuts, position the circular saw
against the workpiece as shown in the figure. It
is best to carry out a trial cut.
45 0
Bosch Power Tools