Urmet 2 Voice 1083/48 Manual De Instrucciones página 13

5.4. PARAMETER ASSOCIATED TO PROGRAMMING LED (1)
COLOUR
Parameter to be configured
door unit type
Parameter 1:
door unit ID
Parameter 2:
Parameter 3: door opener
Parameter 4: call button enabling
Parameter 5: call b utton a ssociation
(*) with switchboard call
(*) Function only possible if door unit is configured as main unit.
5.5. DEFAULT CONFIGURATION
Parameter Function
Parameter 1 Door unit type
Parameter 2 Door unit ID
Parameter 3 Door opener
Parameter 4 Call button enabling
Parameter 5 Call button association with switchboard call
6. HOW TO RESET DEFAULT SETTINGS
Press the PROGRAM button (10) briefly to go to configuration state. The LEDs (1) will blink during this
step.
Then hold the BUTTON (7) pressed for longer than 10 seconds.
The door unit will generate two 2-second long beeps and all parameters will be reset before exiting
configuration state.
7. ADVANCED CONFIGURATION (WITH WiFi CONFIGURATION)
Prepare the device as WiFi access point for advanced configuration of the audio-video door units Ref.
1083/48 and audio door units Red. 1083/38. To start this type of configuration, follow that shown in the
instruction booklet on the Urmet website, which can be downloaded by framing the QR Code shown below
with the camera of your smartphone or tablet:
Audio-video door unit Ref. 1083/48
http://qrcode.urmet.com/default.aspx?
prodUrmet=142027&lingua=en
DS1083-117B
LED (1)
Main
LED C: Green
Secondary
Address 0
LED C: Red
Address 1
Privacy
LED B: Orange
Free
No button enabled
Only the calling button (7)
LED A: Green
is enabled
Both buttons are enabled LEDs on blinking
Not active
LED A: Red
Arm
Audio door unit Ref. 1083/38
Parameter value
Default
Main
Address 0
Privacy
Both buttons enabled
Not active
http://qrcode.urmet.com/default.aspx?
prodUrmet=142025&lingua=en
LED state (4)
LEDs off
LEDs on steady
LEDs off
LEDs on steady
LEDs off
LEDs on steady
LEDs off
LEDs on steady
LEDs off
LEDs on steady
13