Tabla de contenido
Publicidad
If the unit has already been programmed, at feeding, after the selfdiagnostic, the unit starts
operating.
During the selfdiagnostic the display shows a count down (5-4-3-2-1).
5. Step connection preliminary test
If the unit has not been programmed yet (first installation) and the display shows ""
manual switching of the steps (relays) is possible through the keys
This function allows to check the wiring and the switching contactors.
6.
Set up
Respect the following sequence to enter the SET UP. This procedure provides against
unauthorized modifications of data.
1.
Select MANUAL mode operation and disconnect the step.
2.
Press and keep pressed the key
3.
Press contemporary the key
start flashing.
The enter the parameters follow the indication table bellow.
Led indication (according to table below)
.
for 5 seconds until the LEDs "AUTO" and "MAN"
Foward parameters
Save setting
Backwards parameters
Set parameters
19
or
.
Publicidad
Tabla de contenido
