Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
This immersion blender is equipped with overload protection so
that it does not overheat and cause any permanent damage. During
operation, if you notice that the speed indicator lights on the front of
the housing are blinking, stop use, remove the battery and allow it to
cool down for approximately 90 seconds.
CLEANING INSTRUCTIONS
NOT FOR WATERJET CLEANING.
THE BOLT
CORDLESS LITHIUM IMMERSION BLENDER MUST BE
™
CLEANED AND DRIED AFTER EACH USE, ACCORDING TO THE
FOLLOWING INSTRUCTIONS.
Always remove the battery pack and shaft from housing before
cleaning the metal blade.
dishwasher safe.
TO WASH BY HAND
For Food Service Applications
• Wash, rinse, and sanitize the stainless steel shaft of the
immersion blender prior to initial use, after each use, or
whenever it will not be used again within a period of 1 hour.
• Washing solutions based on non-sudsing detergents, and
chlorine-based sanitizing solutions having a minimum chloride
concentration of 100 PPM are recommended.
The following washing, rinsing, and sanitizing solutions, or their
equivalents may be used.
SOLUTION
Washing
International Products
Corporation LF2100
Liquid Low-Foam
Rinsing
Sanitizing
(8.25% Hypochlorite
The stainless steel shaft is
PRODUCT
Cleaner
Plain Water
Clorox
®
Regular Bleach
Concentration)
DILUTION IN WATER
1%–2%: 1¼ – 2¾
Ounce/Gallon (lower dilution of
1% for normal cleaning and up
to 2% for more stubborn soils)
2 Teaspoons/Gallon
(Alternately, a bleach with 5.25%
Hypochlorite Concentration
can be used at dilution of
3 teaspoons/gallon)
9
TEMPERATURE
Room
Temperature
Warm 95˚F (35˚C)
Publicidad
