Descargar Imprimir esta página

General Description (Fig. 1); Electromagnetic Fields (Emf) - Philips HR1568/01 Manual De Instrucciones

Publicidad

Idiomas disponibles

Idiomas disponibles

English
introduction
Congratulations on your purchase and welcome to Philips! To fully benefit from the
support that Philips offers, register your product at www.philips.com/welcome.

general description (Fig. 1)

On/off switch and speed selector (5 speeds + turbo setting)
A
Eject button
B
Motor unit
C
Cord storage facility
D
Cord clip for fixing the cord
E
Kneading hooks (HR1568/HR1566 only)
F
Beaters
G
Vibration disc (HR1568/HR1566 only)
H
Spatula (HR1568/HR1566 only)
I
Sieve (HR1568/HR1566 only)
J
Mixer holder
K
3.5-litre glass bowl (HR1568 only)
L
3.5-litre bowl (HR1566/HR1564 only) with lid (HR1566 only)
M
1.8-litre bowl with lid (HR1566 only)
N
Rotating plate (HR1568 only)
O
Stand
P
Holder release button
Q
important
Read this user manual carefully before you use the appliance and save it for future
reference.
Danger
-
Do not immerse the motor unit in water nor rinse it under the tap.
Warning
-
Check if the voltage indicated on the bottom of the appliance corresponds to
the local mains voltage before you connect the appliance.
-
Do not use the appliance if the mains cord, the plug or other parts are damaged.
-
If the mains cord is damaged, you must have it replaced by Philips, a service
centre authorised by Philips or similarly qualified persons in order to avoid a
hazard.
-
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
-
Children should be supervised to ensure that they do not play with the
appliance.
Caution
-
Always insert the beaters or the kneading hooks (HR1568/HR1566 only) into
the mixer before you connect it to the mains.
-
Lower the beaters or kneading hooks (HR1568/HR1566 only) into the
ingredients before you switch on the appliance.
-
Unplug the mixer before you remove the beaters or kneading hooks (HR1568/
HR1566 only) and before you clean it.
-
This appliance is intended for household use only.
-
Never use any accessories or parts from other manufacturers or that Philips
does not specifically recommend. If you use such accessories or parts, your
guarantee becomes invalid.
-
Do not let the appliance run for more than 10 minutes without interruption. If
you want to process large quantities of ingredients, let the appliance cool down
first before you continue.
-
Do not clean the plastic parts of this appliance in the dishwasher. They are not
dishwasher proof.
-
Do not use a beater and a kneading hook (HR1568/HR1566 only) or two
different types of beaters to mix or knead ingredients.
-
HR1568 only: to avoid thermal shocks, do not put the hot glass bowl on a cold
surface or clean it in cold water immediately after you have removed it from the
oven or microwave. Do not place the glass bowl in the refrigerator when it is still
hot or place the glass bowl in a hot oven straight from the refrigerator.
-
HR1568 only: be careful when you handle the glass bowl. It may break if you
drop it.

Electromagnetic fields (EMF)

This Philips appliance complies with all standards regarding electromagnetic fields
(EMF). If handled properly and according to the instructions in this user manual, the
appliance is safe to use based on scientific evidence available today.
2
Using the appliance
Mixing without the stand
1
Insert the beaters or kneading hooks (HR1568/HR1566 only) into the mixer
('click'). If necessary, slightly turn the beaters or kneading hooks while you do
this (Fig. 2).
Insert the beater or kneading hook with the blue collar into the larger opening and
the one with the large white octagonal collar (HR1568/HR1566 only) or the brown
collar (HR1564 only) into the smaller opening.
2
Put the plug in the wall socket.
3
Put the ingredients in a bowl.
-
For the best results, first put the liquid ingredients in the bowl and then add the
dry ingredients.
-
For the right quantities and processing times, see section 'Quantities and
processing times' below.
4
Lower the beaters or kneading hooks (HR1568/HR1566 only) into the
ingredients and switch on the mixer. (Fig. 3)
If you want to stop mixing for a while, switch off the appliance and put it (with the
beaters or kneading hooks still attached) on its heel until you continue.
5
When you have finished mixing, switch off the appliance and remove the plug
from the wall socket.
6
Press the eject button to release the beaters or kneading hooks (HR1568/
HR1566 only) and remove them from the mixer (Fig. 4).
Mixing on the stand
1
Place the mixer on the stand (Fig. 5).
First fit the front of the mixer into the snap hook at the front of the mixer holder and
then press down the rear end of the mixer ('click').
2
Press the holder release button and tilt the holder with the mixer
backwards (Fig. 6).
3
Insert the beaters or kneading hooks (HR1568/HR1566 only) into the mixer
('click'). If necessary, slightly turn the beaters or kneading hooks while you do
this (Fig. 7).
Insert the beater or kneading hook with the blue collar into the larger opening and
the one with the large white octagonal collar (HR1568/HR1566 only) or the brown
collar (HR1564 only) into the smaller opening.
4
Put the plug in the wall socket.
5
Put the ingredients in the bowl.
-
For the best results, first put the liquid ingredients in the bowl and then add the
dry ingredients.
-
For the right quantities and processing times, see section 'Quantities and
processing times' below.
6
Place the bowl on the stand. (Fig. 8)
7
Press the holder release button and move the holder with the mixer on it
into horizontal position so that the beaters or kneading hooks (HR1568/
HR1566 only) are lowered into the ingredients (Fig. 9).
8
Switch on the mixer.
9
When you have finished mixing, switch off the appliance and remove the plug
from the wall socket.
10
Press the holder release button and tilt the holder with the mixer on it
backwards (Fig. 10).
11
Press the eject button to release the beaters or kneading hooks (HR1568/
HR1566 only) and remove them from the mixer (Fig. 11).
12
Press the mixer release lever at the rear end of the mixer holder (1) and lift
the mixer off the holder (2) (Fig. 12).
Using the sieve (hR1568/hR1566 only)
You can use the sieve to remove lumps and impurities from ingredients such as flour,
sugar or cacao. When the mixer is operating, the vibration disc shakes the sieve. The
ingredients in the sieve are thus added finely and uniformly, which ensures a softer
and more homogeneous result.
1
Place the mixer on the stand and place the bowl with liquid ingredients on the
stand.
2
Insert the beater with the blue collar into the larger opening and the one
with the large white octagonal collar (i.e. the vibration disc) into the smaller
opening (Fig. 13).
Note: You can only use the sieve together with the beaters.
3
Press the holder release button and move the holder with the mixer on it
into horizontal position so that the beaters are lowered into the ingredients.
4222.005.0097.1

Publicidad

loading

Este manual también es adecuado para:

Hr1566/04Hr1564/00Hr1566/00Hr1564/03Hr1568/03