Leica TV Screen 100 Instrucciones Abreviadas página 23

HANGING BRACKET ASSEMBLY
▸ Check the table below to ensure the intended wall space is suitable for the installation
▸ Use an 8 mm drill bit for two holes at a height of 1497 mm above the TV stand and at a horizontal distance of approx. 1100 mm (550 mm each to the right and
left of the center point of the Leica Laser TV)
• The horizontal distance can be adjusted slightly as needed. The hanging brackets must not be too close together (that would negatively impact on stability)
or too far apart (the screen could no longer be attached).
▸ Hold the upper left hole of the hanging bracket (
▸ Drill the second hole at the marked position
• Only two holes are needed for each of the hanging brackets (
▸ Insert the expansion bolts ( Z1
▸ Hold the hanging brackets against the wall and secure them in place with the screws (
▸ Make sure the hanging brackets are attached securely
▸ Hook the connecting rod ( X ) into the hanging bracket
▸ Hook the adjusting rod ( ) into the connecting rod (
W
Note
• Ensure that the hanging brackets are anchored in the support structure of the wall when installing on a drywall. Where that is not the case, sufficient load
bearing capacity cannot be guaranteed.
Space requirements for the installation
A
100"
min. 2.3 m
(Overall width)
) against the hole in the wall and mark the wall for the lower right hole
V
) into the bore holes
)
X
B
min. 1.7 m
(Elevation above the TV stand of
your Laser TV)
).
V
) provided
Z1
Distances for hanging bracket
C
1100 mm
12
D
1497 mm