Zafferano poldina LD0682B4 Instrucciones De Uso página 3

poldina
Rechargeable floor lamp
4.3"
11cm
23.6"
60cm
0.4"
1.2cm
This product contains a class F light source
1. Tips for use:
This product is exclusively for lighting purposes and:
A) It must not be exposed to heavy mechanical loads or contamination; B) It can be installed and used only after checking the state of the pro-
duct; check that is not dirty and has not been damaged during storage; C) Installation and maintenance must be carried out when the appliance
is switched off; D) Any alterations to the product, any tampering and any failure to comply with the instructions provided may make the appliance
hazardous; E) When fully assembled, the lamp (head+structure, without the recharging base), reaches an IP54 rating, making it ideal
for outdoor use. The light fixture (top) alone on the recharging base has an IP20 rating, making it unsuitable for outdoor use; F) All metal and plastic
surfaces should be cleaned with a soft dry cloth; G) The company Zafferano shall not be held liable for any damage caused due to its products being
assembled in any manner that does not comply with the instructions provided.
2. Technical data of the lamp:
- Power: 2.2 W
- Volt: DC 5 V
- Color temperature: 2200 - 2700 - 3000 K
- Lumen LED: 234-251-256 lm
- Lithium battery pack included (see section accessories included); for instructions about how to replace the battery pack, please consult the
website: ZafferanoAmerica.com. Use only original batteries for replacement.
- Charge: 6 h
- Battery life: 10+ h
- Class: III
- Protection rating: IP54
- CRI>80
3. Battery charger technical data:
- Contact charging base: INPUT/OUTPUT 5Vdc - 1A; cavo USB 1.1 Mt.
- Charger: INPUT AC100-240V 50/60Hz; OUTPUT 5Vdc- 1A.
- The lamp works correctly even when connected to the charging base.
- It is advisable to use the original charger and charging base. Alternatively, you can use a certified 1A max. charger.
4. Important:
- We recommend cleaning using only a soft, dry cloth. The use of aggressive cleaning agents or abrasive cloths, and any accidental knocks, may
damage the delicate leaf finish.
- The support surface for the lamp must not exceed a 15° tilt or it will fall.
- The battery has an overload protection function.
- To preserve the integrity of the battery, we recommend keeping the charge between minimum 20% and maximum 80%; if the lamp is not used for
long periods, it is advisable to regularly charge/discharge the product.
- Please refer to local laws for the proper disposal and recycling of the battery.
DESIGNED BY ZAFFERANO SRL IN ITALY, MADE IN PRC • Imported by Zafferano America LLC, 301 Penhorn Avenue Suite 5 Secaucus, NJ 07094, USA
For more information and updates visit our website • ZafferanoAmerica.com
3
LD0682B4 white
LED DIMMER
LD0682N4 dark grey
2.2W LED • 234-251-256lm • 2200-
LD0682R4 rust
2700-3000K • IP54
• CRI>80 • 5Vdc max 1A
4.3 x H 23.6" / 11 x H 60 cm
INCLUDED NOT INCLUDED
LD0340RA
Single-contact
Multi-socket USB
charging station
charger (8xUSB)
BAT04703706701900
Replacement battery pack
KIT00009006800204
Replacement LED board
INSTRUCTIONS FOR USE
ASSEMBLY INSTRUCTIONS
SWITCHING ON / SWITCHING OFF / DIMMING
Quick taps to:
- turn on
- turn off the lamp
<1 sec
<1 sec
COLOR TEMPERATURE CONFIGURATION
4 sec
<1 sec
2200K
When the lamp is switched off, press Quick tap on the touch sensor
lightly for 4 seconds until a steady blue to change the color temperature
LED lights up of the lamp
INDICATOR LEDS
PERMANENT RED LED
FLASHING RED LED
the battery charge is lower than 20%, charging in progress
charging is recommended.
When the charge is depleted (1%), the lamp
does not switch on but emits three white flashes
as an alert to charge
Charge the battery before initial use.
To correctly charge the lamp, we recommend that you:
1) Connect the USB cable to the adaptor;
2) Put the plug into the electrical socket
3) Place the lamp on the charging base;
4) When fully charged, disconnect the plug from the electrical socket
DESIGNED BY ZAFFERANO SRL IN ITALY, MADE IN PRC • Imported by Zafferano America LLC, 301 Penhorn Avenue Suite 5 Secaucus, NJ 07094, USA
For more information and updates visit our website • ZafferanoAmerica.com
When the lamp is switched on, lightly press the touch sensor to
obtain the desired brightness. Every time you turn it on, the light
intensity returns to 100%
<1 sec <1 sec 4 sec
2700K 3000K
Light pressure for 4 seconds to set
the new color temperature and switch off
the lamp
PERMANENT GREEN LED
the battery is 100% charged,
disconnection from the power charger
is recommended
4