cecotec BOLERO FLUX PM Manual De Instrucciones página 31

ENGLISH
1. PARTS AND COMPONENTS
Fig. 1
1. Off button
2. Low power button
3. Medium power button
High power button
4.
5. Light button
NOTE:
the graphics in this manual are schematic representations and may not exactly match the
device.
2. BEFORE USE
- This appliance is packaged in a way as to protect it during transport. Take the device out
of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent damage to the device when
transporting it in the future. In case the original packaging is disposed of, make sure all
packaging materials are recycled accordingly.
- Make sure all parts and components are included and in good conditions. If there is any
piece missing or in bad conditions, contact the official Cecotec Technical Support Service
immediately.
Box content
- Kitchen hood
- Assembly kit
- Instruction manual
3. INSTALLATION
The dimensions of the kitchen hood are shown in Figure 2.
- Before installing the kitchen hood, make sure that the area is clean to prevent it from
sucking in dust or dirt.
- Please note that the kitchen hood must not share the same ventilation duct with other
appliances that use gas or other fuses.
60
Bolero Flux PM 603500 Inox B / PM 903500 Inox B
- To facilitate air outlet, the ventilation duct should have a curvature of ≥120° and should be
connected to the outside wall.
- After installation, ensure that the kitchen hood is level to prevent grease build-up on the
end. Fig. 3
1. The kitchen hood should be placed at a distance of 65-75 cm above the cooking surface
for best effect.
Install the wall hook in a suitable location and set the installation height. Keep it aligned.
2.
Use the screws to fix it to the wall. Fig. 4
3. Fix the outer bracket on the chimney, Fig 5, and make sure that the inner part of the chimney
can be adjusted to the installation height, as well as that of the flexible connection pipe.
Then, install the flexible connection pipe in the chimney of the kitchen hood, Fig. 6.
4. Place the kitchen hood on the hook on the wall. Fig. 7
5. Adjust the height of the inner part of the chimney to the position of the inner bracket and
fix it with screws (ST4*8 mm). After adjusting the position of the kitchen hood, fix the
body with safety screws (ST4*30 mm). Fig. 8
Note: there are two safety ventilation ducts in the back housing.
4. OPERATION
Power buttons
1. To switch on the kitchen hood, press any of the power buttons.
2. If you press the low power button, the kitchen hood will beep, and the motor will operate
at low speed.
If you press the medium power button, the kitchen hood will beep, and the motor will
3.
operate at medium speed.
4. If you press the high-power button, the kitchen hood will beep, and the motor will operate
at high speed.
If you press the light button, both bulbs will light up. Press it again and the light will switch
5.
off.
6. Press the off button, the motor will switch off.
5. CLEANING AND MAINTENANCE
Cleaning aluminium filters
Do not use corrosive detergents to clean grease from the aluminium filters. Regular cleaning
of the filters will prolong the life of the appliance and keep it in good working order. Figure 9
shows how to release the filter from the hood.
Follow the instructions below:
ENGLISH
Bolero Flux PM 603500 Inox B / PM 903500 Inox B
61