Scheppach KS1200 Traducción De Manual De Instrucciones Original página 25

e) When the wheel is binding or when interrupt-
ing a cut for any reason, switch off the power
tool and hold the cutting unit motionless until
the wheel comes to a complete stop. Never at-
tempt to remove the wheel from the cut while
the wheel is in motion otherwise kickback may
occur. Investigate and take corrective action to
eliminate the cause of wheel binding.
f) Do not restart the cutting operation in the
workpiece. Let the wheel reach full speed and
carefully re-enter the cut. The wheel may bind,
walk up or kickback if the power tool is restarted
in the workpiece.
g) Support any oversized workpiece to minimize
the risk of wheel pinching and kickback. Large
workpieces tend to sag under their own weight.
Supports must be placed under the workpiece
near the line of cut and near the edge of the work-
piece on both sides of the wheel.
Warning! This electric tool generates an electromag-
netic field during operation. This field can impair active
or passive medical implants under certain conditions. In
order to prevent the risk of serious or deadly injuries, we
recommend that persons with medical implants consult
with their physician and the manufacturer of the medical
implant prior to operating the electric tool.
ATTENTION: Depending on how you will use the pow-
er tool, the actual values may deviate from the indi-
cated values. Take measures to protect yourself from
noise pollution. In this process it is important to take
the complete sequence of operation into account. This
also includes moments during which the power tool
operates without load and moments during which it is
turned off. Suitable measures comprise amongst other
things regular maintenance and service of the power
tool and the insertion tools, regular breaks and the ap-
propriate planning of the sequences of operation.
The specified vibration emission value can be used to
compare one electric tool with other.
Residual risks
Even if you use this electric power tool in accord-
ance with instructions, certain residual risks can-
not be rules out. The following hazards may arise
in connection with the equipment's construction
and layout:
• Lung damage if no suitable protective dust mask
is used.
• Damage to hearing if no suitable ear protection is
used.
• Health damage caused by hand-arm vibrations if
the equipment is used over a prolonged period or
is not properly guided and maintained.
6. Technical Data
Rated voltage:
Power input:
Idle speed:
Adjustment angle:
Grinding wheel Ø (inside):
Grinding wheel Ø (outside):
Grinding wheel thickness:
Totally insulated:
Weight:
Noise values
The total noise values determined in accordance with
EN 61029.
sound pressure level L
uncertainty K
sound power level L
uncertainty K
Wear hearing protection.
The effects of noise can cause a loss of hearing.
Total vibration values (vector sum - three directions)
determined in accordance with EN 61029.
Grinding
Vibration emission value ah = 3,73 m/s²
K uncertainty = 1,5 m/s²
Warning!
The specified vibration value was established in ac-
cordance with a standardized testing method. It may
change according to how the electric equipment is
used and may exceed the specified value in exception-
al circumstances.
The specified vibration value can be used to compare
the equipment with other electric power tools.
www.scheppach.com
pA
pA
WA
WA
230V~ 50Hz
220W
7500 min
-1
35° - 0° - 35°
10 mm
100 mm
3.2 mm
II
1.8 kg
87 dB(A)
3 dB
100 dB(A)
3 dB
GB | 25