Publicidad
Idiomas disponibles
Idiomas disponibles
4
OPERATION & INSTALLATION MANUAL FOR PC-RLH8/10
8) Hook other fixixng nails (3 postions) at square holes of air panel.
NOTE:
When removing the receiver kit after
installing the air panel;
1) The corner position of the receiver kit
can be lifted when a coin or a "-"
shaped driver is inserted into the dent
part
and twisted downward. With
lifted, twist a coin or a "-" shaped driver
at the positions of
and
, the whole
receiver kit can be lifted.
2) After disconnecting the fixing nails (3
positions),slide the receiver kit in the
arrow direction
and remove the
receiver kit.
PC-RLH10
1) Install the wireless receiver kit, the indoor unit and the air panel at the same time.
2) In case that the wireless receiver kit is installed after installing the indoor unit, turn off the
power source of the indoor unit.
3) Remove the right resin side cover.
(1) Open the air intake grille.
(2) Remove the attaching screw (M4) of resin cover side cover.
(3) Slide the resin side cover forward as shown below.
4) Remove the remote control cover.
(1) Insert the screwdriver or stik (within Ø5) into the service hole.
(2) Press the hook of reomte control cover bu using the screwdriver or stick.
Press by Screwdriver
Remote Control
Switch Cover
Attaching Place of
Wireless Receiver Kit
Coin or"-" Shaped Driver
Lifting
Dent Part
Fixing Screw (M4)
Inside of Resin Side Cover
Hooking Part
Hooking Plate
Hole for Wiring
Drain Pan
and Servicing
Pan
Square Hole
Wireless
Receiver Kit
Publicidad
