RCA 25250RE1 Guia Del Usuario página 12

All manuals and user guides at all-guides.com
Connections & Setup
Base Station
The phone may be connected to two line (RJ14C) wall jacks to
accommodate all two lines.
1. Choose an area near an electrical outlet and a telephone wall jack
(RJ11C), and place your cordless telephone on a level surface, such as a
desktop or tabletop, or you may mount it on the wall.
2. Plug the power supply cord into the power jack on the back of the base
and the other end into an electrical outlet.
CAUTION: To reduce risk of personal injury, fire, or damage
use only the 5-2757 (base) power adaptor listed in the
user's guide. This power adaptor is intended to be correctly
orientated in a vertical or floor mount position.
3. Connect the telephone line cords:
If you have 2 single-line wall jacks installed in your home or office, you
can use adaptors/couplers (not included) to combine the 2 single
telephone lines into 1 dual lines. The adaptor/coupler may look similar
to the one pictured here and can be purchased from your local
telephone products retailer.
Line 2
Line 1
Or, you can use the 2 single telephone lines plug into the 2 jacks on
the back of the telephone.
Line 1
Line 2
If you have Line 1 and Line 2 wired into one wall jack in your home or
office, you can use one of the supplied telephone line cords to connect
from the wall jack to the Line 1 + 2 jack on the back of the phone as
shown below.
Line 1 + 2
12