Publicidad
Idiomas disponibles
Idiomas disponibles
UNFOLDING :
1. Swing the side frames outward until a distinct click is heard.
2. Before using, test walker by grasping the side frames and, with some force, attempt to fold them inward. The walker will
remain locked in the OPEN position if it is engaged properly.
FOLDING :
3. Pull up the lever and pivot the corresponding side frame inward toward the front cross brace.
4. Repeat the same procedure for the remaining side frame.
HEIGHT ADJUSTMENT :
5. Depress knob and slide leg up and down.
6. Tighten the knob into hole that provides correct height.
7. Repeat for each leg, making sure the walker is level.
CARE AND MAINTENANCE
Failure to care for and monitor your product may result in the risk of serious injury.
•
Clean the walker regularly with warm water and a soft cloth. Do not use abrasive products, detergents or solvents.
•
Dry with a clean, dry soft cloth.
•
Make sure there is no accumulation of dirt or debris under the tips.
•
Do not use cleaning products containing phenol or chlorine, as this could damage aluminium and polyamide materials.
•
Periodically check the wear and strength of all screws and bolts. Replace all broken, damaged or worn parts immediately.
•
If there is a malfunction, do not repair the rollator yourself. Consult an authorized dealer.
CHANGE OF OWNERSHIP
The product can be reused. It must first be cleaned and disinfected in accordance with hygiene instructions. When transferring
your product, remember to hand over all the necessary technical documents to the new user. Beforehand, the product must be
inspected by an authorised specialist.
RECYCLING
When the product has become unusable and you have to throw it away: please contact your specialist dealer. If you wish to carry
out recycling for yourself, ask your local waste management company for disposal guidelines.
STORAGE
Failure to observe the storage conditions can lead to deterioration of the product and thus to the risk of serious injury.
•
Do not store your product for an extended period of time near a heat source or in the sun (e.g. behind a window or near a
radiator) or near a cold source.
•
Keep away from all flames and sources of sparks.
•
Respect the conditions for storing your product.
•
In a dry and temperate place
•
Protect your product from dust, corrosion (e.g. abrasive elements, sand, sea water, salty air).
•
Store all removed parts together in the same place (or locate them if necessary) to avoid mixing them with other products
when reassembling.
•
All components must be stored without any load (do not place any objects that are too heavy on the product elements, do
not jam anything...).
•
Checklist :
•
To keep the product in good condition, check before each use, and check regularly as follows:
Version Mai 2023
6
Publicidad
