Create SILKAIR CONNECT Manual Del Usuario página 12

2. Elongate the exhaust pipe and snap the flat end of the exhaust pipe joints into the hole of
the window sealing plate assembly.
Important Notice: The length of the exhaust hose shall be between 280 and 1,500mm, and
this length is based on the specifications of the air conditioner. Do not use extension tubes
or replace it with other different hoses, or this may cause a malfunction. Exhaust host must
be not blocked; otherwise it may cause overheating.
M A NUAL DR AI NAGE
• When the air conditioner stops after the water tank is full, turn off the machine power and
unplug the power plug.
Notes: Please move the appliance carefully, so as not to spill the water in the water tank at
the bottom of the body.
• Place the water container below the side water outlet behind the body.
• Unscrew the drainage cover and unplug the water plug, the water will automatically flow
into the water container.
Notes: Keep the drainage cover and the water plug properly.
• During drainage, the body can be tilted slightly backwards.
• If the water tank cannot hold all the water, before it is full, stuff the water outlet with the
water plug as soon as possible to prevent water from flowing to the floor or the carpet.
• When the water is discharged, stuff the water plug, and tighten the drainage cover.
CONTINUOUS DRAINAGE (OPTIONAL, ONLY APPLICABLE TO DEHUMIDIFYING MODE)
• Unscrew the drainage cover, and unplug the
water plug.
• Set the drainage pipe into the water outlet.
• Connect the drainage pipe to the bucket.
E NGL I SH
12
DRAINAGE INSTRUCTIONS
*Drainage pipe not included in SILKAIR
CONNECT and CONNECT PRO.