Publicidad
Idiomas disponibles
Idiomas disponibles
- Check that the adjustment knobs work properly before use.
- Before use, check that all parts are present and in good condition. In the event of damage, please contact your dealer.
- Carefully follow the assembly instructions and ensure that all components are correctly secured before use.
- Before use, apply the brakes to the castors.
- If any parts are damaged, broken or worn, please contact your dealer.
MOUNTING AND USE
ASSEMBLY AND USE :
Assemble crossbars K and M to frame J using bolts L. Observe the position of wheel lock crossbar K as shown in the diagram.
Tighten bolts L. Ensure that all 4 wheels are in contact with the ground.
Insert the sliding tube C (square section) into the frame J and adjust it to the required height, then tighten the clamping knob F.
Insert the clamping rod B into the tube C (cylindrical part) until the clamping nut makes contact with the tube.
The two oblique parts are now in contact.
Place clamping washer E (small diameter in tube C) and loosely tighten clamping knob D.
Note: Clamping washer E must be fitted to lock plate A in the inclined position.
Slide the table top A into the sliding tube C and tighten the clamping knob D.
The height of the table can be adjusted using the clamping knob F.
The tilt of the table can be adjusted using clamping knob D.
When in use, make sure that clamping knobs F and D are correctly tightened.
Version Juin 2023
7
Publicidad
