Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE
The first production phase may last a little longer than the following ones.
►
The ice cubes do not reach full size until around the third production
►
phase, depending on the water and ambient temperature.
The production time is dependent on the water and ambient temperature.
►
Stopping ice cube production
WARNING
Drain the water from the water tank
►
Otherwise, bacteria can start to build up!
Press the
♦
green.
To switch off the appliance completely, remove the ice cubes and pull the
♦
plug from the mains power socket.
Allow the appliance to defrost and check whether there is any water left in
♦
the rear part of the appliance. To do this, tip the appliance slightly forwards
so that the water runs into the water tank
To let the water out of the water tank
♦
it juts out over the edge of the worktop and you have access to the drain
opening
front feet still have a firm foothold.
Hold a container that is suitably large to hold the expected amount of water
under the drain opening
Once the water has drained out, push the cap firmly back into the drain
♦
opening
SEMK 105 A1
button
to stop ice production. The control lamp
on the underside of the appliance. Ensure, however, that the
and pull out the cap.
.
after a maximum of 24 hours.
.
, pull the appliance forward so that
GB │ MT
flashes
│
47
■
Publicidad
