Publicidad
Idiomas disponibles
Idiomas disponibles
delta k
HEIZFSYSTZME
Dear customer,
Thank you very much for purchasing a high-quality, energy-saving and modern ceramic heating system ofthe
company SBI. We hope you will enjoy our product. If you are not satisfied with the product or if there are
reasons for a complaint, please do not hesitate to contact us.
Attention
Please read this instruction manual carefully before installing and commissioning this ceramic heating
system. Please note that we will not assume any liability for damage that occurred due to non-observance of
this manual or due to misuse.
Safety instructions
1. The electronically controlled heating unit type Delta K160 / K240 / K320 must only be used in waterbeds
with a minimum filling height of 15cm.
2.
The electronically controlled
heating
unit type Delta
K80 / K100
must only be used
in so-called
"lightweight* waterbeds or waterbed mattresses with a maximum water volume of 150 litres.
3.
The heating unit must only be operated with AC 220-230 V.
4.
Itis recommended not to connect the heating unit to the mains supply unless the mattress has been filled
with water. If you would like to pump down the water, disconnect the heating unit from the mains supply first.
5. This heating unit should not be used for medical treatment.
6.
You must not replace the connecting cable. If a defect on the cable occurs, the entire heating unit must be
replaced.
7. Needles and sharp edges should not come in contact with the waterbed.
8.
Pillows and bedcovers should not be in contact with the heatingpads.
9.
Children are not allowed to play with the heaters.
10. Children, disabled people (mentally, physically or sensory) are not allowed to operate the heater, like
persons with lack of knowledge how to operate the heater unless they are thoroughly informed and trained or
supervised.
Heating-up
We recommend that the waterbed is filled with hand-hot water (approx. 28°C). When you fill the waterbed with
cold water, excessive amounts of air bubbles and condensation water may build up. In addition to this, the
heating unit will take much longer to heat the water in your waterbed to the required temperature.
If no hot water is available for filling the waterbed, the heating-up time will be accordingly extended. The
heating-up of the water in your waterbed depends on the water volume and the ambient temperature and is on
average approx. 0.5° Cto 1°C per hour.
Operation
Please keep in mind that you need two heating units in so-called DUAL waterbeds.
1.
Position the ceramic heating unit in the base area of your waterbed with a distance of approx. 10 cm to the
foot, lightly to the corner of the respective watermattress (in case of the DUAL system).
2.
Please make sure that the cable of the heating unit is not pinched between the base unit and the mattress
base.
3.
The heating unit is completely positioned below the safety liner of the watermatress . Please make sure
that no folding of the vinyl takes place above the heating unit and that the surface remains smooth.
4.
Use the regulating switch of the thermostat to set the required temperature according to your personal
preferences. The indicator lamp will flash when the heating unit is heating up; it will go out automatically when
the desired temperature is reached.
Publicidad
