Parts Identification; Cleaning And Care - Mondial V-68-6P Manual De Instrucciones

MONDIAL STAND FAN - V-68-6P

PARTS IDENTIFICATION:

1. Pedestal
2. Base
3. Central Hole
4. Fastening Nut
5. Cover
6. Metal Part of the Pedestal
7. Height Adjustment Latch
8. Fan Rod
9. Tilt Adjustment Latch
10. Vertical Holes
8 UK E
FIG. A
11. Rear Grid
12. Guide Pines
13. Nut
14. Fan Blades
15. Motor Shaft
16. Blades Button
17. Front Grille
18. Guide
19. Lower Holes
20. Side Latches
21. Fastening Bolt
INTRODUCTION
Thank you for trusting in Mondial. To ensure proper operation and maintenance of the product, carefully
read the instructions in this manual and keep it in the event that you may need in the future. We
recommend that you also keep the packaging in case of repairs, and dispose of all plastic bags that
could become dangerous toys for children.
The appliance is very easy to use. Just connect it to the electricity supply socket (220-250V).
If you need more information, please contact Mondial.
Advice:
The use of Mondial appliances by children needs clear instructions of use and constant
supervision during use of the appliance.
OPERATION
The instrument consists of the following parts, see fig.A:
Before using the appliance:
˃ Unpack the appliance.
˃ Clean the appliance. See "Cleaning and Care"
Use (See fig.A)
Assembly
1. Position and insert the pedestal (1) to the base (2), aligned with the central hole (3). Insert the
fastening nut (4) in the lower part of the base (2), turning it clockwise until the two parts are
fastened.
2. Raise the metal part of the pedestal (6), releasing and subsequently tightening the height
adjustment latch (7), and attach the fan rod (8) forcing down. If necessary, adjust the tilt of the
fan by releasing and subsequently tightening the tilt adjustment latch (9).
3. Position the vertical holes (10) of the rear grid (11) in the guide pins (12) with the carry handle
facing up. Insert the nut (13) and rotate clockwise to lock the two parts.
4. Fit the fan blades (14) onto the motor shaft (15), aligning the flat face of the shaft with the flat
face of the blades. Insert the fan blades button (16) and turn counterclockwise to lock the two
parts together.
5. Position and place the front grill (17) with the guide (18) facing up, aligning the lower holes (19)
of the two parts. With the two grids aligned, tighten the side latches to (20) the grill in place.
Insert the fastening bolt (21) into the lower holes until the two parts are locked.
Oscillation control

1. Push the oscillation knob to oscillate.
2. Pull the oscillation knob to stop

CLEANING AND CARE

1. Remove all items of packaging from the fan.
2. Remove the locking nut from the motor shaft.
3. Position the rear guard over the motor shaft, ensuring that the notches are correctly aligned
and then secure with the locking nut.
4. Align the fan blade with the flat part on the motor shaft and secure by tightening the blade cap
by turning counter-clockwise.
5. Attach the front guard centre hook to the middle of the rear guard and secure by pushing the
guards together until they click into position .
6. Open the locking clip. The guard bottom nut and screw must also be fitted to ensure secure fitting.
UK E 9