Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: Push coupler back until it
clicks to prevent air from escaping
through the quick connect.
2.
Plug the power cord into the
correct branch circuit receptacle.
(Refer to Voltage and Circuit
Protection paragraph
in the
Installation section of this
manual.)
3.
Open the drain valve (counter-
clockwise) fully to permit air to
escape and prevent air pressure
build up in the air tank during the
break-in period.
_Risk
from Flying
__
Objects.
Always
wear certified
safety equipment:
ANSi Z87.1 eye protection
(CAN/
CSA Z94.3) with side shields as
debris can be kicked up into face.
4.
Move the Auto/Off switch to
"Auto" position. The compressor
will start.
5.
Run the compressor
for 15
minutes. Make sure the drain
valve is open and there is
minimal air pressure build-up in
tank.
6.
After 15 minutes, close the drain
valve by turning clockwise. The
air receiver will fill to "cut-out"
pressure and the motor will
stop.
The compressor is now ready for use.
Before Each Start=Up
1.
Place Auto/Off switch to "Off".
2.
Pull regulator knob out, turn
counter-clockwise
until it stops.
Push knob in to lock in place.
3.
Attach hose and accessories.
NOTE: The hose or accessory will
require a quick connect plug if the
air outlet is equipped with a quick
connect.
Risk of unsafe
operation.
Firmly
grasp air hose in hand when
installing or disconnecting
to
prevent hose whip.
Risk of unsafe
operation.
Do not
use damaged
or worn accessories.
_Too
much air
__
pressure
causes a
hazardous
risk of bursting.
Check
the manufacturer's
maximum
pressure
rating for air tools and
accessories.
The regulator
outlet
pressure
must never exceed the
maximum
pressure rating.
Risk of unsafe
operation.
Compressed
air from the unit may
contain water condensation
and
oil mist. Do not spray unfiltered
air
at an item that could be damaged
by moisture.
Some air tools and
accessories
may require filtered
air. Read the instructions for the air
tools and accessories.
Bow to Start
1.
Turn the Auto/Off switch to
"On/Auto" and allow tank pres-
sure to build. Motor will stop
when tank pressure reaches "cut-
out" pressure.
2.
Pull the regulator knob out and
turn clockwise to increase
pressure. When the desired
pressure is reached push knob in
to lock in place. The compressor
is ready for use.
Risk of fire or
explosion.
Always
operate the air compressor
in well=
ventilated
areas free of gasoline
or other combustible
vapors, if
the compressor
is being used to
operate a sprayer DO NOT place
near the spray area.
_lf
any unusual
__
noise or vibration
is noticed,
stop the compressor
immediately and have it checked
by
a trained service technician.
The compressor
is ready for use.
N004395
14-ENG
Publicidad
