Publicidad
Idiomas disponibles
Idiomas disponibles
Air Conditioner
Features
To begin operating
the air conditioner,
follow
these steps:
1. Set the temperature
selector to the highest number
(coldest or coolest setting).
2. Set the made control to the High Coo! setting.
3. Adiust the louvers for comfortable
air flow (see Air Directional
Louvers).
4. Once the room has cooled,
adiust the temperature
selector to the setting you find mast comfortable.
Refer to the
instructions below.
Temperature
Selector
This is used to set the desired
room temperature
when the unit is being
operated
in the "COOL
MODE".
To set the desired
room temperature,
rotate
the selector switch to the desired
setting. After the set temperature
is achieved,
the thermostat
will automatically
start and stop the compressor
in order to maintain
the desired
set temperature.
Rotate the temperature
selector clockwise
for higher cool setting. Higher
cool
settings
will provide
lower room temperature.
Rotate the temperature
selector counter-clockwise
for lower cool settings.
Lower cool settings will provide
higher
room temperature.
Cool Mode
The desired
cool setting
is selected
by rotating
the MODE knob to the
appropriate
location.
"High
Cool" has maximum
cooling
effect
and airflow.
"Low Cool"
has minimum cooling
effect
and airflow.
Fan Mode
Rotate the MODE knob to select your choice of fan speeds for air circulation
only.
Note: When selecting
a fan speed, the compressor
will not run.
ADDiTiONAL
THINGS YOU SHOULD
KNOW
Please always
wait 3 minutes when turning
unit off then on again,
and when changing
from cool to fan and back to
cool. This prevents
compressor
from overheating
& possible
circuit breaker
tripping.
Failure to follow
these instructions may be harmful
to your unit.
Models
with a key hole overflow
drain hole can use drain kit 5304481680
to connect a 1/2
inch drain hose for safe
disposal
of excess system water.
This part can be ordered
at www.SearsPartsDirect.com.
LOUVERS
AUGER WHEEL
Air directional
louvers control air flow direction.
Your air
conditioner
has the 2-way
directional
system described
below.
The louvers will allow
you to direct
the air Left or Right throughout
the
room as needed.
Rotate the Auger
Wheel
until the desired
Left or Right
direction
is obtained.
There are a total
of 2 possible
air directional
orientations
available
with this system.
5
Publicidad
