Publicidad
Idiomas disponibles
Idiomas disponibles
PROBLEM
SOLUTION
Oven will not start
• Replacefuse or reset circuitbreaker.
Control panel lighted,
yet oven will not start
LOCKED appears
on display
CAUTION_OVEN
HOT
appears on display
POSSIBLE
CAUSES
Afuse in your home may be
blown or the circuit breaker
tripped.
Power surge.
Plug not fully inserted into
wall outlet.
Door not securely closed.
Door not securely closed.
START/ENTER button net pressed
after entering cooking selection.
Another selection entered
already in oven and STOP/CLEAR
button not pressed to cancel it.
Cooking time not entered after
pressing COOK TIME.
STOP/CLEAR was pressed
accidentally.
Food weight not entered after
selecting AUTO DEFROST,
BREAD DEFROST or
EXPRESS DEFROST.
Food type not entered after
pressing AUTO COOK.
The control has been locked.
The temperature inside the
oven is greeter than 200°R
One of the sensor cooking
pads was pressed when the
temperature
inside the oven
was greater than 200°R
• Unplug the microwave oven, then plug it back in.
• Make sure the 3-prong plug on the oven is fully inserted
into wall outlet.
• Open the doer and close securely.
• Open the door and close securely.
• Press START/ENTER.
• Press STOP/CLEAR.
• Make sure you have entered cooking time after pressing
COOK TIME.
• Reset cooking program and press START/ENTER.
• Make sure you have entered food weight after selecting
AUTO DEFROST, BREAD DEFROST or EXPRESS DEFROST.
• Make sure you have entered a food type.
• Press and hold START/ENTER for about 3 seconds
to unlock the control.
• This is normal.
• These features will not operate when the oven is hot.
Floor of the oven is warm
The cooktop light is located
• This is normal.
even when the oven has
below the oven floor. When
not been used
light is on, the heat it produces
may make the oven floor
get warm.
You hear an unusual
You have tried to change
• Many of the oven's features are preset and cannot
low-tone beep
the power level when it is
be changed.
not allowed.
Oven emits a smoky odor
Oils on the stainless steel cavity
• This is normal.
and gray smoke after
are burning off after using the
using the Convection
Convection feature the first
feature
few times,
31
Publicidad
