Polygroup SUMMER WAVES ELITE FRAME POOL Manual Del Usuario página 11

14. Go around and check all fittings, legs, and beams are
properly installed and secured in place. Make sure the
drain fitting is plugged securely and the cap is in place.
NOT FOLLOWING THE STEPS ABOVE WILL MAKE THE POOL FILL UNEVENLY AND THE POOL MAY LEAN
TO ONE SIDE AND COLLAPSE (SEE PICTURE). YOUR POOL SHOULD BE STRAIGHT AND VERTICAL TO THE
GROUND. IF YOUR POOL IS LEANING AT ALL, THE GROUND MAY NOT BE LEVEL AND YOU WILL NEED TO
START OVER.
FAILURE TO FOLLOW THE INSTRUCTIONS ABOVE WILL CAUSE POOL TO COLLAPSE AND WILL VOID THE
WARRANTY!
IMPORTANT: BEFORE ADDING WATER TO YOUR POOL YOU MUST INSTALL THE POOL WALL
FITTINGS OR ENTIRE FILTRATION SYSTEM FIRST. BEFORE ADDING WATER TO YOUR POOL
FOLLOW THE INSTRUCTIONS BELOW.
If your pool included openings or you are going to purchase a filter pump system, position the Suction & Return fitting locations so they are 10 to 21 feet
from the electrical outlet you plan to use for the pool pump.
If your pool came with Fittings - Install both the Suction and Return fittings to the pool wall before filling the pool.
RX CARTRIDGE FILTER PUMP
Outside Pool Wall
Inside Pool Wall
Water Cap Suction Fitting Fitting Gasket Suction Fitting
Washer
SUCTION FITTING
NOTE: For Sand Filter Pump / Cartridge Filter Pump CP2000-C, please follow the Sand Filter Pump / Cartridge Filter Pump CP2000-C
owner's manual to set up the fitting. Please check the water pump's instruction manual for more instructions.
Please Note: The Black Rubber gasket (Fitting Gasket) should always be slid over the threaded plastic suction or return fitting and be on the inside before the fitting
is placed through the pool wall to make a watertight connection.
Make sure to put on both the Water Cap and the Service Plug while you fill your pool, or until you are ready to add a filtration system.
Outside Pool Wall
Inside Pool Wall
Service Plug
Fitting Lock
Return Fitting
Return Fitting Fitting Gasket
Nut
Diverter
RETURN FITTING
OWNER'S MANUAL
15. Fill up the pool with about an inch (1") [2.54cm] of water. Stop filling
and smooth out all wrinkles from the pool floor, working outwards from
the center, so that it fills evenly.
Note: If more than one to two inches (1"-2") [2.54cm-5.08cm] of
water collects on any one side before the pool starts filling in the
center, the pool is not level enough, and must be corrected.
16. Install the filtration system as per its instruction manual.
17. Continue to fill the pool to approximately eight inches (8") [20.32cm]
below the top rim.
SFX SKIMMERPLUS FILTER PUMP
Inside Pool Wall
Fitting Lock
Nut
SUCTION FITTING
Outside Pool Wall
Inside Pool Wall
Return Fitting
Diverter
Service Plug Fitting Gasket RF Nut
Locking Ring Return Fitting Suction Fitting
Washer
90° Elbow
RETURN FITTING
11