Troy-Bilt 01924 Manual Del Propietário página 6

ASSEMBLY
Your generator reqores some assembHy and is ready for
use after it has been property serviced with the
recommended oiH and fuel
If you have any probHems with the assembHyof your
generator, pHeasecaHH t he generator heHpHine at
1-888-61 1-6708. If caHHing f or assistance, pHeasehave the
model revision, and seriaHnumber from the data tag available.
See "KnowYour Generator" for data tag Hocation.
Remove Generator From Carton
H. Set the carton on a rigid fiat surface.
2. Remove everything from carton except generator.
3. Open carton compHeteHyby cutting each corner from
top to bottom.
4. Leave generator on carton to instaHH wheeH kit.
Install Wheel
Kit
The wheeH kitisdesignedto greatly improve the portability
of your generator.
NOT_:: Whee[ kit is not intended for overothe-road use.
You wiHHneed a socket wrench with H/2" or H3mm sockets
and a needHeonose pHiers to install[ this kit.
[. PHacebottom of generator cradHe on a fiat, even
surface.TemporariHy pHace unit on bHocks to ease
assembHy.
2. SHideaxHethrough both axHe mounting brackets on
cradHe frame, as shown in Figure H.
3. SHidewhee[ over axHe.
NOT_:: Be sure to install[ both wheeHs with the air
pressure vaHveon the outboard side.
4. PHacee-ring onto groove in axHe.You may add the fiat
washer if desired.
Cap Screw
\
mex
Handle Assembl,
Flat Washer
Support Leg
Hex Nut .......
Cap Screw
Axle
Wheel
/
,/
EoRing
0