Oster 078129-900-051 Manual De Instrucciones página 5

Installing Sanding Band onto Sanding Drum
1.
2.
3.
4.
5.
LED Indicator Light
•
•
•
Charging Nail Grinder
Before using your Nail Grinder for the first time, allow the
battery to fully charge – up to 110 minutes. Charging is
complete when LED Indicator on Nail Grinder shows a
solid green light.
1.
2.
3.
29-900_15EFSM1.indd 5
Hold collet nut with thumb
and forefinger to prevent
spinning.
With other hand, using a
small Philips screwdriver
turn top screw counter
clockwise 2-3 rotations to
contract the drum. (Diagram 2)
Slide the old band off (if replacing).
Slide the new sanding band on.
Expand the drum by turning the top screw clockwise.
This will secure the band onto the drum and prevent it from sliding off.
Solid Red – Charging in process
Solid Green – Charging complete
Flashing Red – Low battery
Plug the power cord of the charging base into an outlet with the
rated voltage for your unit. The adaptor should only be connected to
an AC 120V, 60Hz power supply or 220V, 50-60 Hz power supply,
depending on model and plug configuration.
Ensure that power switch on Nail Grinder is in OFF (center) position
Insert the Nail Grinder into charging base so that front faces
outward and the contacts are aligned with the contacts on the
charging base. The front of the Nail Grinder is the side containing
the locking button, power switch and indicator light. The indicator
light on front of nail grinder will be solid RED indicating charging
is in process. The indicator light will be solid GREEN when fully
charged.
English-4
Diagram 2
7/9/15 1:45