Create WARM CONNECT 2500 Manual Del Usuario página 8

1. Press on/off switch and press Power button to start the setting.
2. Press + or - to adjust the target temperature, 5-35 ºC.
3. Press ||| to adjust the heating position (I, II or III).
4. Press Timer button to set the 24 hours timer off, "0" means the timer function is off. Press
+ or - to set desired timer. The indicator light will light up when this function is activated.
5. Press Timer button for 3 seconds, the screen will be locked and the light will be dim. To
unlock the heater, press Timer button for 3 seconds again.
6. The heater has a heating boost function. The heater will continuously work for 12 hours,
while the temperature sensor does not work. In this mode, the indicator
(The function needs to be set on the app only)
7. When the heater is working, the
8. For all the operation, the indicator light will stop twinkle when the user doesn't operate
the appliance for 10 seconds, it will work based on the setting before the twinkle stops.
9. The light of the screen will be dim after stopping the operation for 30 seconds.
CREATE HOME application is available for Android and iOS (look for the app on Google Play
or App Store or scan the QR code below). Depending on the provider, there may be costs
involved in downloading the app.
This appliance allows you to operate the appliance via your home network 2.4 Gh. A prerequi-
site is a permanent WiFi connection to your router and the free app CREATE HOME.
We recommend disconnecting the appliance from the power supply when you are away from
home to prevent unintentional switching on while you are away.
1. Press button more than 3 seconds, the indicator
rapidly. Open the app and follow the instructions to connect it.
2. Press button once to turn on or turn off the Wi-Fi function.
This appliance is provided with a safety device which will switch off the heater in case of ac-
cidental tipping over. To reset, disconnect the plug from the power for a few minutes, remove
the cause of tipping over, then plug the appliance in again. If it still cannot be reset, ask a
qualified technician to check and repair.
Your heater is fitted with a safety device to switch off the heater in the event of overheating.
If the safety device is activated, please turn the heater off, unplug the appliance and let it
completely cool, inspect for blockage of air inlet or outlet, attempting to restart the heater
then after.
If the heater fails to operate or the safety device switches the heater off again, return heater
to your nearest service center for examination or repair.
E NGL I SH
8
OPERATION
will be light up.
APP CONNECTION
iPhone OS
TIP OVER SAFETY PROTECTION
OVERHEATING SAFETY DEVICE
will be light up.
Android OS
on the top right corner will flash