Create JET WASHER Manual Del Usuario página 11

A DJ USTAB LE SPR AY NOZ ZLE
The adjustable nozzle will allow you to use any variety of spray patterns
from a full fan spray to a direct stream spray.
When using the pressure washer to clean wood decks, siding, vehicles,
etc., always start using the fan spray and begin spraying from a minimum
36 inches away to avoid damaging the surface of the material you are
cleaning.
Always begin by spraying in a testing area free and clear of people and ob-
jects.
Moreover, this nozzle has a setting to use water mixed with detergent (add
detergent to the deposit on the back of the pressure washer).
Warning: High pressure jets can be dangerous if subject to misuse. The
jet must not be directed at persons, live electrical equipment or the appli-
ance itself. Do not direct the jet against yourself or others in order to clean
clothes or foot-wear.
DE TE RG E N T BO T T LE
The included detergent bottle will allow you to use many types of liquid
detergent or other products (such as descalers, grease removers, polishes,
etc.) on your work surfaces.
Soap application can only be used in low pressure mode.
Remove the cap from the soap bottle and use only liquid products. Do not
add any water to the bottle. The pressure washer will mix the soap and
water automatically.
Once you have applied the soap and water solution to the surface to be
cleaned, replace the bottle with the appropriate cleaning accessory and
rinse the soapy surface.
WARNING: High pressure hose must not loop. During operation, the appliance must be posi-
tioned on a firm, stable surface.
Caution: ALWAYS turn off the unit's motor BEFORE turning off the unit's water supply. Serious
damage could occur to the motor if the unit is run without water.
1. Turn on the water supply tap fully.
2. Unlock the trigger (by pressing the safety button first and then press the trigger) for a few
seconds, let the water flow out from the nozzle.
3. Check if water leaks from joints. If water leaks, please reconnect the water hose, the spray
gun or the lance to make sure each accessory are connected perfectly.
4. Connect to power supply.
5. Set the power switch at the position "ON/I".
6. Press the trigger and start the washer.
WARNING: Check that the supply voltage and frequency correspond to those specified on the
appliance data plate. The appliance should only be connected to a mains power supply via a
security breaker (Max.30mA) to cut off the electricity supply in the instance of a short circuit.
ACCESSORIES
OPERATING INSTRUCTIONS
E NGLI SH
11