KitchenAid 5K45 Serie Manual De Uso Y Cuidado página 10

PRODUCT USAGE
BEATER TO BOWL CLEARANCE
Your Stand Mixer is adjusted at the factory so the Flat Beater just clears the bottom of
the Bowl. If, for any reason, the Flat Beater hits the bottom of the Bowl or is too far away
from the Bowl, you can correct clearance easily.
1
Turn Speed Control Lever to "0". Unplug
Stand Mixer.
NOTE: When properly adjusted, the Flat Beater will not strike on the bottom or side of
the Bowl. If the Flat Beater or the Wire Whip is so close that it strikes the bottom of the
Bowl, coating may wear off the beater or wires on whip may wear.
CARE AND CLEANING
IMPORTANT: Allow the appliance to cool completely before putting on or taking off
parts, and before cleaning the appliance.
1
Always be sure to unplug Stand Mixer
before cleaning. Wipe Stand Mixer with a
soft, damp cloth. Do not use
household/commercial cleaners. Wipe
off beater shaft frequently, removing any
residue that may accumulate. Do not
immerse in water.
*Included with select models only. Also available as an optional accessory.
**Can also be used to scrape your bowl.
10
W11555951D.indb 10 W11555951D.indb 10
2
Lift motor head. Turn screw slightly
counterclockwise (left) to raise Flat
Beater or clockwise (right) to lower Flat
Beater. Make adjustment with Flat Beater,
so it just clears surface of Bowl. If you
overadjust the screw, the Bowl lock lever
may not lock into place.
2
Bowls, Pouring Shield*, Flat Beater*, Flex
Edge Beater*,
Pastry Beater* and
and Dough Hook may be
Scraper**
washed on the top rack in dishwasher. Or,
clean them thoroughly in hot sudsy water
and rinse completely before drying. Do
not store beaters on shaft.
5/20/2022 6:45:59 PM 5/20/2022 6:45:59 PM