Publicidad
Idiomas disponibles
Idiomas disponibles
Connect the pressure regulator by inserting the gasket that is usually supplied
with the cylinder.
Always use the new gasket that is supplied.
Tighten the regulator onto the cylinder (left thread).
Check that the gas pipe is not kinked. Rotate the tube to eliminate any bends.
Open the tap on the cylinder.
Leave the stove taps closed for 5 minutes and check that there is no smell of
gas.
To check the rubber hose for leaks, use soapy water: if no bubbles form, there
are no leaks.
Warning: do not use flames to check for gas leaks!
USE OF THE
PRODUCT:
1. Lightly press the tap of the burner you want to light and turn it anticlockwise.
2. Bring a flame close to the burner.
3. Wait until it is completely lit and turn the knob to adjust the intensity of the
flame.
4. To turn off the burner, turn the knob clockwise to OFF.
5. After use or before storing the product, turn off the stove by first closing the
valve on the bottle. This will burn all the gas, and the rubber tube will remain
completely empty. At this point it is also possible to close the stove tap.
6.
Wait until the stove is completely cold, at least 30
CLEANING AND
Clean the stove regularly between uses, especially after a long period of
inactivity.
Before cleaning, make sure the stove is completely cold.
Make sure the valve on the cylinder and the burner knobs are closed
(OFF position). Remove the grill for easier cleaning.
Use a damp sponge to remove any food encrustations. For normal
soiling, a damp cloth is sufficient.
Do not use abrasive substances or solvents.
The only maintenance required concerns the gas pipe and the cylinder.
Check that they are up to standard and in good condition. For the
connection between the pressure regulator and the cylinder, always use
the new gasket
MAINTENANCE:
supplied.
minutes.
9
Publicidad
