Comelit Simplebus2 Manual Tecnico página 9

Red
No internet
-
connection
Internet conn.
present but not
-
connected to the
Comelit Cloud
Restore fac- Restore factory
tory settings
Device working and
- connected to the
Comelit Cloud
Technical specifications
Power supply voltage
Min. absorption
Max. absorption (in audio)
Min. absorption
Max. absorption (in audio)
Simplebus2 bus line connection to 4888C
Absorption in standby (CV1 used)
Max. absorption (in audio, CV1 used)
Simplebus2 bus line connection to 1210A
Absorption in standby (CV1 not used)
Max. absorption (in audio, CV1 not used)
Operating temperature
Operating humidity (max. RH)
Dimensions (4 DIN modules) (mm)
Fig. 2 page 4
1. Indicator LED (LED on when power present / LED
off when power absent)
2. Power supply socket
3. Ethernet Port
4. USB port (not used)
5. Mobile antenna connector
6. Reset button (not used)
7. LED indicating the strength of the mobile signal
(minimum recommended level 3 LEDs lit)
8. LED indicating mobile network availability (4G
coverage required)
Technical specifications
Input voltage 9 - 30 VDC
Absorbed
< 5W
power
Green Yellow
Cable
disconnected
Ethernet
communica-
tion active
Ethernet
communica-
settings
tion active
No Ethernet
comm.
12 - 56 VDC
0.96 W @12
VDC
3 W @12 VDC
1.6 W @56 VDC
3.7 W @56 VDC
1.8 mA
270 mA
1.8 mA
76 mA
-5 - 50°C
95% max.
90x70x59 mm
Connector 4-pin industrial DC power supply
socket
Mobile module 4G (LTE) – Cat 4 up to 150 Mbps,
3G – Up to 42 Mbps, 2G – Up to
236.8 kbps
LAN 1 x RJ45 port, 10/100/1000 Mbps
Protocols TCP, UDP, IPv4, IPv6, ICMP,
HTTP, HTTPS, SSL v3, TLS, SSH,
DHCP, MQTT
CPU ARM Cortex-A7 1.2 GHz CPU
RAM 128 MB
FLASH memory 512 MB
Ethernet 1 x RJ45 port, 10/100/1000 Mbps
USB Virtual network interface via USB
(not enabled)
Status LEDs 3 x connection status LEDs, 5 x
connection strength LEDs, 2 x
LAN status LEDs, 1 x power LED
Antenna
SMA for LTE
connector
Reset Restore factory settings button
(not enabled)
Operating
-40 - 75°C
temperature
Operating
10 - 90% non-condensing
humidity
IP protection
IP30
rating
To configure the kit, carry out the 4 steps
below:
1. Wire the kit and activate the connection
service
Wire art. 1406 to the 4G gateway, switch on the power
and proceed with activation of the connection via the
MyComelit app, in the System Management area, as
illustrated below:
2.
1.
GESTIONE SYSTEM
MANAGEMENT IMPIANTI
Finally, follow the setup wizard to complete internet
connection activation.
2. Set DIP-switch S1 according to the
configuration of your system
Module 1406 stores up to 50 Simplebus addresses,
which corresponds to 50 apartments that can be
configured in your system.
3.
4. ID32
1406
DISPOSITIVI
DEVICES
5.
9