Superrollo RM10MSF Instrucciones De Montaje página 25

Malfunction characteristics and remedies
Characteristic
The motor does not run (total failure).
The motor does not run (total failure).
Possible cause
There is no mains voltage.
The remote control does not function.
Device malfunctions.
Motor overload due to sluggish roller shutter as a
result of displaced slats.
Motor overload due to sluggish roller shutter as a
result of icing.
The maximum operating time (four minutes) has
been exceeded.
The connections have not been carried out
correctly.
Remedy
Make sure that the supply voltage (230 V) is available.
Make sure that the device is connected correctly.
Information on this can be found in the section entitled
Connecting the device from page 22.
Have work on the voltage supply carried out by a qualified,
trained specialist electrician only.
Make sure that a functional 27A-12V battery is inserted.
Make sure that the device is disconnected from the mains
power supply.
Remove the device.
Information on this can be found in the chapter entitled
Dismantling the device from page 27.
Make sure that the device is disconnected from the mains
power supply.
Make sure that the slats are horizontal.
Establish the current supply.
Move the roller shutter up and down.
Lubricate sluggish areas with wax.
Clear away the icing.
Allow the device to cool for approx. 20 minutes.
Make sure that the device is operated correctly.
Make sure that the terminal points are set correctly.
Make sure that the roller shutter runs smoothly.
Make sure that the device is connected correctly.
Information on connecting the device can be found in the
section entitled Connecting the device from page 22.
Have work on the voltage supply carried out by a qualified,
trained specialist electrician only.
Rectifying malfunctions
25