Aprimatic ONEPRO 1111 Manual De Usuario página 7

O N E PR O
User M anu al
Generate codes
Press the buttons 1 and 2 of the
ONEPRO simultaneously until
the LED starts blinking, let go
the buttons and the LED will
turn off.
To finalize the process, press
and let go the button where
you want to insert the chosen
brand. The LED should fix and
turn off.
Direct copy
Press and keep pressing the
button 1 of the remote, and
then press 3 times the button 2.
The LED will blink slowly, let go
the buttons.
Press the buttons according to
the code associated with the
brand you want to generate.
(See exemples 1 and 2)
Program the remote on the
receiver following the brand
procedures.
At a distance of 1 cm press
the button of the original
remote you want to copy. If the
ONEPRO LED starts blinking
fast, it means that the copy was
made successfully, you can let
go the buttons.
Exemple 1:
Code
Brand Frequency
(Buttons to press)
APRIMATIC 1 1 1 1 433 MHz
The button 1 should be press 4
consecutive times.
Notes:
On a BFT remote to transmit the hidden code, press the buttons 1 and
4 simultaneously until the LED of the ONEPRO starts blinking.
Now open the receiver programming and press the button where you
previously inserted the code (the LED of the receiver will fix)
Wait until the LED of the ONEPRO turns o e press again the same
button to finalize the programming (the LED of the receiver will blink
fast and then turn off).
Special Functiones
The ONEPRO remote allows to easily identify a pre-programmed
brands.
To do that, you need to follow the following steps:
1 — Press simultaneously the buttons 3 and 4 until the LED starts
blinking, then you should let go the buttons and the LED will turn off.
2 — To identify the brand/code pre-programmed in the remote, press
the button you already programmed.
The amount of times the LED blinks will corresponde to the 4 digit code
associated with the brand. The LED will blink 4 separate times, the
amount of times the LED turns on and off will correspond to a number
associated with the brand codes shown in the table on the back.
In case of a direct copy (fixed code) the ONEPRO will blink 4 sequences
of 4 blinks each.
While the ONEPRO LED blinks,
press the button that you want
to save the code.
The LED will blink and turn
off, meaning the copy was
concluded.
Exemple 2:
Code
Brand Frequency
(Buttons to press)
AUTOMAT-EASY 1 2 4 2 433 MHz
First press the button 1, then the
button 2,now press the button
4 and press the button 2 again.
After you dialled the code, the
LED will blink fast, waiting for you
to select a button to program.
Notes:
To program other buttons just
repeat the same steps.
On the second step, if the LED
blinks only 3 times and turns o, it
means that the code wasn't
copied properly.
It is possible to programme
dierent buttons with dierent
brands and frequences.