DeWalt DW622 Traducido De Las Instrucciones Originales página 28

english
QUICK ADJUSTMENT USING THE GRADUATION
WITH ZERO RESET RING
1. Loosen the depth stop locking bolt (n).
2. Unlock the plunge limiter (o) by turning it
counterclockwise.
3. Lower the router carriage until the cutter is in
contact with the workpiece.
4. Tighten the plunge limiter (o).
5. Set the quick adjuster (p) to zero using the ring
(v). The depth stop (m) must be in contact with
the revolver depth stop (l).
6. Adjust the depth of cut using the quick adjuster
(p) and the corresponding graduation. The
adjusted depth of cut is indicated by the
arrows (w).
7. Tighten the depth stop locking bolt (n).
TRIPLE DEPTH ADJUSTMENT USING THE
REVOLVER DEPTH STOP
The revolver depth stop (l) can be used to set three
different depths. This is particularly useful for deep
cuts, performed in steps.
– Place a depth template between the depth
stop (m) and the revolver depth stop (l) to
adjust the exact cutting depth.
– If required, set all three screws.
FINE ADJUSTMENT
When not using a depth template, or if the depth of
cut needs readjustment, it is recommended to use
the fine adjuster (q).
1. Adjust the depth of cut as described above.
2. Set the fine adjuster to zero using the ring (x).
3. Rotate the fine adjuster (q) to the required
position: one turn corresponds to approximately
1 mm and 1 mark to 0.1 mm.
Depth Adjustment with Router
INSTALLED IN INVERTED POSITION (FIG. 4)
1. Remove the depth stop (m) and replace it with
the depth stop (DE6956) available as an option.
2. Connect the threaded rod of the depth stop (m)
to the revolver depth stop (l).
3. Set the depth of cut using the adjuster on the
depth stop (m).
WARNING: For installing the router in
inverted position, refer to the relevant
instruction manual on the stationary tool.
26
Fitting the Parallel Fence (fig. 1, 5)
1. Fit the guide rods (e) to the router base (j).
2. Tighten the locking bolts (i).
3. Slide the parallel fence (h) over the rods.
4. Tighten the locking bolts (d) temporarily.
5. Remove the dust extraction adaptor (r) and
close the outlet using the dust extraction plug
(y) supplied with the tool.
Adjusting the Parallel Fence (fig. 6)
1. Draw a cutting line on the material.
2. Lower the router carriage until the cutter is in
contact with the workpiece.
3. Tighten the plunge limiter (o).
4. Position the router on the cutting line.
5. Slide the parallel fence (h) against the workpiece
and tighten the locking bolts (d).
6. Adjust the parallel fence (h) using the fine
adjuster (g). The outer cutting edge of the cutter
must coincide with the cutting line.
7. Firmly tighten the end lock (t).
Fitting a Guide Bush (fig. 7)
Together with a template, guide bushes play a
valuable part in cutting and shaping to a pattern.
– Fit the guide bush (z) to the router base (j) using
the screws (aa) as shown.
Connecting a Dust Extractor
(fig. 1, 5)
Connect a dust extractor hose to the dust extraction
adaptor (r) in the router carriage column or to the
dust extraction outlet in the parallel fence (f).
Prior to Operation
1. Check that the cutter is correctly installed in
the collet.
2. Select the optimal speed using the electronic
speed control dial.
3. Set the cutting depth.
4. Connect a dust extractor.
5. Make sure the plunge limiter is always locked
before switching on.