Before use
This Wet/Dry shaver can be used for
wet shaving with shaving lather or for
dry shaving. You can use this water-
tight shaver in the shower and clean
itin water. Treat yourself to wet lather
shaves for at least three weeks and
notice the difference. Your Panasonic
Wet/Dry shaver requires a little time
to get used to because your skin and
beard need about a month to adjust
to any new shaving method.
Charge the shaver for at least 8 hours
before using it for the first time or
when it has not been in use for more
than six months.
Parts identification
(see fig. 1)
Protective cap
System outer foil
System outer foil release buttons
Foil frame
inner blades
Foil frame release buttons
On/Off switch
Low battery indicator
Charge status lamp
Trimmer
Trimmer handle
Charging adaptor holder
Charging adaptor
Rotatable stand
BF8000009000000@6
Charging adaptor
(see fig. 1)
Lift the charging adaptor holder until
it clicks in when charging the shaver.
(see fig. 1(A))
(Restore the charging adaptor holder
when carrying the unit.) (see fig. 1(B))
Rotate the stand on the bottom of the
charging adaptor when you need
extra stability. (see fig. 1(C))
Charging
(see fig. 2)
Place the charging adaptor upright
on a flat surface. Plug the adaptor into
an AC outlet.
Place it upright into the charging
adaptor with the switch facing toward
the front.
The charge status lamp will glow red
when the shaver is placed on a right
charging position. It will flicker red
when the charging is completed (see
fig. 2(A)).
You can fully charge the shaver in
1 hour if the low battery indicator
flashes green (see fig. 2(B)).
A full charge will supply enough
power for about 7 shaves (three min-
utes per shave for a normal beard).
You can always store your shaver in
the charging adaptor to maintain full
power capacity. This shaver cannot
be overcharged.
Before traveling, charge it fully for
1 hour if you will not be taking the
charging adaptor with you.
In case your shaver is discharged,
you may quick charge it for one shave
in about five minutes.