Publicidad
Idiomas disponibles
Idiomas disponibles
USER
REPLACEABLE
SERVICE
PARTS
REPLACEMENT
PART
Spool with 0.080"
Trimmer
Line
Assist
Handle
Bolt Carriage.
1/4-20
Wing Nut
Shield Assembly
PART NUMBER
952701666
530038584
530015820
530016118
530069752
_WARNING:
Perform
the following
steps after each use.
• Stop
the unit
and disconnect
the power
SOUrCe
when
not
in use,
• Carry the unit with motor stopped.
• Store the unit so the line limiter blade can-
not cause injury.
• Store unit and extension
cord indoors
in a
high, dry place out of the reach of children.
Store unit unplugged.
• Store unit with all guards in place. Position
unit so that any sharp object cannot acci-
dentally
cause injury.
TROUBLESHOOTING
TABLE
,_
WAR NIN G: Always stop unit and disconnectfrom the power source beforeperforming
all of the recommended
remedies below exce 3t remedies that require unit to be operating.
TROUBLE
CAUSE
REMEDY
Trimmer
head
1. Crowding
trimmer
line
1. Allow tip of line to do the cutting.
stops under a
against
material being
load or does not
cut.
turn when switch
2. Electrical
failure.
2. Contact your authorized service dealer.
is pressed.
3. Thrown
circuit breaker.
3. Check Breaker
Box.
4. Debris stopping
head.
4. Remove
debris.
Line does not
1. Line improperly
routed
1. Check line routing.
advance
or
in head.
breaks while
2. Line improperly
2. Rewind line tightly and evenly.
cutting,
wound
into spool.
3. Incorrect
line size
3. Use onIy 0.065 inch (1.65 mm) dia. line.
4. Not enough line
4. Remove
cover and pull 4 inches
outside
of head.
(10 cm) of line out of head.
5. Dirt buildup on unit.
5. Clean unit.
Line welds onto
1. Line size is incorrect.
1. Use only 0.065 inch (1.65 mm) dia. line.
spool.
2. Incorrect
spool.
2. Replace with correct
spool.
3. Line is being crowded
3. Cut with tip of line fufly extended.
against
material being
cut.
Line releases
1. Line improperly
1. Check line routing.
continuously,
routed in head.
2. Spool damaged.
2. Replace
spool.
Line usage is
1. Line improperly
routed
1. Check line routing.
excessive,
in head.
2. Line size is incorrect.
2. Replace
spool.
3. Crowding
line against
3. Cut with tip of line fully extended.
material
being cut.
4. Spool worn or damaged.
4. Replace
spool.
Line pulls back
1. Too tittle line outside
1. Remove cover
and pull 4 inches
into head.
of head.
(10 cm) of line outside
of head.
2. Line size incorrect.
2. Use only 0.065 inch (1.65 mm) dia. line.
Publicidad
