Lenco CD-500 Manual De Usuario página 18

Factory Reset
This function resets the unit to the original factory settings.
1. Turn on the unit in DAB mode or FM mode.
2. Press and hold the MENU button to access the menu control.
3. Press the or
4. Press the or
5. Press the or
Software Version Check
You can check the software version of the unit.
1. Turn on the unit in DAB mode or FM mode.
2. Press and hold the MENU button to access the menu control.
3. Press the or
4. Press the or
software version number.
5. Press the MENU button repeatedly to exit the menu control.
BATTERY LEVEL SAVING
In order to save the battery consumption, the unit in CD mode pause or without playback for around 15 minute will
automatically turn off to the power off mode.
No power

Ensure that the unit is switched on and the battery is fully charged.
No sound output

Turn up the volume.
Disc in place but the unit won't play

Ensure that the disc label is facing up.

Ensure that the disc is clean.

PAUSE mode may be activated, deactivate it.

Disc may be damaged or dirty; check and clean the disc.
DAB/FM reception

Ensure the earphone (antenna) wire is fully extended.

Electrical interference in your home can cause poor reception. Move the unit away from them (especially those
with motors and transformers).
Sound interference coming from the earphone

Move any wireless devices (mobile phone, bluetooth device etc.) away from the unit.
button until "System" is highlighted and then press the ENTER button.
button until "Factory Reset" is highlighted and then press the ENTER button.
button until "Yes" is highlighted and then press the ENTER button to reset the unit.
button until "System" is highlighted and then press the ENTER button.
button until "SW version" is highlighted and then press the ENTER button to show the
Trouble Shooting
18