Technical Data; Functional Description - Festool AGC 18 Manual De Instrucciones

English
The user is liable for improper or non-in­
tended use.
5

Technical data

Cordless angle grinder
Motor voltage
Speed (no-load)
Speed settings
Circumferential speed
of sanding tool
Grinding spindle
thread
Sanding tool diameter
Sanding tool thickness
Weight as per EPTA
procedure 01:2014
6

Functional description

[1-1]
Guard
[1-2] Spindle lock
[1-3]
Thread for auxiliary handle
[1-4] Speed control
[1-5] On/off switch
[1-6] Auxiliary handle
[1-7] Insulated gripping surfaces (grey
shaded area)
[1-8] Buttons for releasing the battery pack
[1-9] Capacity button on battery pack
[1-10] Capacity indicator
[1-11] Support points
Accessories shown or described are not always
included in the scope of delivery.
The pictures for the functional description are
on a fold-out page at the beginning of the in­
12
AGC 18
18 V DC
4500 – 8500 min
-1
1
4500 min
-1
2
5300 min
-1
3
6100 min
-1
4
6900 min
-1
5
7700 min
-1
6
8500 min
-1
80 m/s
5/8"
4.5" (115 mm)
max. 1/4" (6.0 mm)
min. 3/64"
(1.0 mm)
5.9 lbs
struction manual. While reading the manual
you can fold out the page for comparison and
quick reference.
6.1 Electronics
Smooth start-up
The electronically controlled smooth start-up
function ensures that the power tool starts up
smoothly.
Speed regulator [1-4]
You can continuously adjust the speed within
the speed range using the adjusting wheel .
This enables you to optimise the speed to suit
the respective material. Please also note the
specifications on the sanding tools.
Constant speed
The preselected motor speed is kept constant
through electronic control. This ensures a uni­
form speed even when under load.
Recoil protection
In the event of a sudden speed reduction, e.g. if
the power tool becomes jammed in a separat­
ing cut, the motor is switched off immediately.
To put the power tool back into operation, it
must first be switched off and then on again.
Restart protection
The built-in restart protection prevents the
power tool from starting up again automatically
if the power is disconnected during continuous
use. To put the power tool back into operation,
it must first be switched off and then on again.
Overheating protection
In the event of overheating, the safety electron­
ics system switches to cooling mode. The motor
continues to run and the constant speed is de­
activated. Let the machine cool down for ap­
proximately 10–20 seconds before using it
and/or fully loading it again.
7 Commissioning
7.1 Holding the power tool correctly
Hold the power tool with both hands using the
insulated gripping surfaces [1-7]: One hand on
the motor housing behind the switch and the
other on the auxiliary handle [1-6].
7.2 Switch on/off
Switching on [2A]
► Push the on/off switch [1-5] forwards.
Pressing the front part of the switch at the
same time locks the on/off switch.