Publicidad
Idiomas disponibles
Idiomas disponibles
TO MOVE FORWARD AND
BACKWARD
The direction and speed of movement is
controlledby the motioncontrol lever. (J)
1. Start tractor with motion control lever in
neutral position,
2. Release parking brake.
3. Slowly move motion control lever to
desired position.
TO ADJUST MOWER CUTTING HEIGHT
The position of the attachment lift lever (A)
determines the cutting height.
TO ADJUST GAUGE WHEELS
Gauge wheels are properly adjusted when
they are slightly offthe ground when mower
is at the desired cutting height in operating
position. Gauge wheels then keep the deck
in proper position to help prevent scalping
in most terrain conditions,
NOTE: Adjust gauge wheels with tractor on
a flat level surface.
1. Adjust mower to desired cutting height
(See "TO ADJUST MOWER CUTTING
HEIGHT" in this section of manual).
2, With mower in desired height of cut posi-
tion, gauge wheels should be assembled
so they are slightly off the ground. Install
gauge wheel in appropriate hole. Tighten
securely.
3. Repeat for all, installing gauge wheel in
same adjustment hole,
• Put attachment lift lever in desired cutting
height slot,
The cutting height range is approximately 1
to 4" (25,4 to 101,6 ram). The heights are
measured from the ground to the blade tip
with the engine not running. These heights
are approximate and may vary depending
upon soil conditions, height of grass and
types of grass being mowed.
• The averagetawn should be cutto approxi-
mately 2-1/2" (63,5 ram) during the cool
season and to over 3" (76,2 mm) during
hot months. For healthier and better look-
ing lawns, mow often and after moderate
growth.
• For best cutting performance, grass over
6" (152,4 mm) in height should be mowed
twice. Makethefirst cut relatively high; the
second to desired height.
TO OPERATE MOWER
Your tractor is equipped with an operator
presence sensing switch.
Any attempt
by the operator to leave the seat with the
engine running and the attachment clutch
engaged will shut off the engine. You must
remain fully and centrally positioned in the
seat to prevent the engine from hesitating or
cutting off when operating your equipment
on rough, rolling terrain or hills.
1. Select desired height of cut with attach-
ment lift lever.
2. Start mower blades by engaging attach-
ment clutch control.
TO STOP MOWER
BLADES
Disengage
attachment clutch control.
_IbCAUTION:
Do not operate the mower
without
either the entire grass catcher, on
mowers so equipped, or the deflector shield
(S) in place.
12
Publicidad
