Sylvania 6427GFG A Manual De Instrucciones página 7

iii!iiiiiiii_iii_iiiiiiiiiiiiiiii_ii,!i_iii
P EPARAT,O. FOR USE
This section describes how to connect this TV to reception and other sources.
[ANTENNA / BASIC CABLE CONNECTION]
When connectinq TV to antenna *For digital signal
1) Connect the RF cable or antenna cable on your home outlet to the ANT. iN jack of this TV.
or
incoming Cable
Rear of this TV
Antenna Selecto_
(if necessary)
COMMERCIALLYAVAiLAbLE
w
d_
as
O
z
O
,5
w
z
z
0
When connectinq TV to basic cable [without box). *For analog reception onmy
1) Connect the RF cable or incoming cable on your home outlet to the ANT. IN jack of this TV.
NOTES:
* For your safety and to avoid damages to the unit, unplug the antenna cable ifom the ANT. IN jack before moving if_e unit.
* if you use an antenna in order to receive analog TV, the same antenna generally wi# work for DTV reception,
Outdoor or attic antennas will be more effective than set-top versions,
* Some cable channels cannot be viewed when the TV is connected to an aerial antenna because DTV program does not cover all
cable channels. You can watch them bY switchiag to the cable connected to CATV,
* To easily switch between antenna and cable wires, you can pumhase 'Antenna Selector" commercially available.
*Once connections are completed, turn on the TV and begin initial setup.
Channel scanning is necessary for the TV to memorize all availabJe channels in your area if using antenna
or basic cable. [Refer to "iNiTiAL AUTO PRESET" on page 13.)
EN