Publicidad
Idiomas disponibles
Idiomas disponibles
Starting and stopping the equipment
- Put the plug into a socket and press the switch. The product will start operating.
- The vacuum power can be regulated by sliding the regulating switch.
Vacuuming liquids
- Before starting to vacuum liquids, insert the sponge filter in place of the HEPA filter.
The product comes with a device with a float and a sponge filter that protect the motor from the
liquids being vacuumed.
ADDITIONAL INSTRUCTIONS FOR THE USE OF THE POWER TOOL SOCKET:
In order to use your vacuum and the power tool socked proceed as follows:
a) Open the protection cap of the socket
b) Insert the plug
c) Activate the switch. At this point vacuum and power tool can operate simultaneously.
Never suck up liquids when using a power tool but only solids
Blowing function
- Insert the suction pipe into the upper hole on the bin and tighten securely.
In this way, the blowing function of the product can be used.
Cleaning the HEPA filter when suction power is weak:
1) Press the red button to make the cleaning lever pop out.
2) Raise the lever into vertical position.
3) Slide the lever inside the hole in order to clean the filter.
Publicidad
