Hitachi H55SC Instrucciones De Seguridad Y Manual De Instrucciones página 9

6. How to install tool
CAUTION:
For tools such as a bull point and a cold chisel,
use only metabo HPT genuine parts.
(1) Clean, then smear the tool shank with the
grease provided.
(2) Slide the tool holder in the direction of arrow
and rotate it 180°.
Turn the notch of the tool shank downward and
insert it fully into the hexagonal hole of the
front cover. (Fig. 2)
(3) Turn the tool holder and align the front cover
mark with the tool holder mark to secure.
NOTE: Remove in the reverse order to
installation.
HOW TO USE THE DEMOLITION HAMMER
1. After placing the tip of the tool in the base hole,
switch ON.
2. By utilizing the empty weight of the machine
and firmly hold the hammer with both hands,
you can effectively control the subsequent
recoil motion. Proceed at a moderate work-
rate, applying too much force will impair
efficiency.
Front cover
Tool shank
Tool holder
Fig. 2
Fig. 3
English
9