EN
rEmovING or INSTALLING
THE bLAdE
Before installing or
NoTE:
removing the blade, make sure that
the button and the machine are off
the chain.
To remove the blade, loosen three
screws and remove the key.
The cover can be removed
simultaneously.
To install the blade, must clear all
debris and other objects on the
slide and the bushing. Use a new
blade with the same size and weight
as the old.
Screw
blade slot
adjustement plate
adjustement plate
14
14
Put the blade on the base plate and
align the edge of the blade with
the inside edge of the plate scale.
Then, adjust the plate on the blade,
then attach the tail of the board to
align it with the back of the base
plate. Tighten the set screw on the
plate. Slide the tail adjustment plate
bushing and cover. Tighten three
screws evenly with key.
Inner of the balence
adjustement
inner of the standard
tail
blade
plate
adjustement
plate tail
rear end of
base plate
the base
plate
When installing the blade,
NoTE:
tighten the blade bolt carefully.
Carefully check that they are
properly tightened.
Install the blade in position and
secure it. The following are
examples of what is right and what
is wrong to do:
(A) Front plate (removable)
(B) Back Plate (fixed)
Correct setting: the blade is flush
with the back plate.
Breaking the surface: Reason: one
or both ends of the blade is not
parallel with the base of the back
plate.
Sunk in front: Reason: one or both
ends of the blade is not parallel with
the base of the back plate (very
low).
Sunk in the rear: Reason: one or
both ends of the blade is higher than
the back plate.
standard
plate
AdjuST THE dEPTH
oF CuT
Turn the screw on the front of the
machine to adjust the cutting depth.
buTToN
stop te trigger
trigger button