Hatco HXMH Serie Instrucciones Originales página 11

General
Hatco Heated Merchandisers are designed for maximum
durability and performance with minimum maintenance.
WARNING
ELECTRIC SHOCK HAZARD:
• Turn OFF power switch, unplug power cord, and allow
unit to cool before performing any cleaning, setup, or
maintenance.
• DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged
or saturated with water.
• Do not steam clean or use excessive water on unit.
• This unit is not "jet-proof" construction. Do not use
jet-clean spray to clean this unit.
• Do not clean unit when it is energized or hot.
This unit has no "user-serviceable" parts. If service
is required on this unit, contact an Authorized Hatco
Service Agent or contact the Hatco Service Department at
414-671-6350.
CAUTION
Do not move or relocate unit for cleaning. Unit is bulky
and heavy.
Daily Cleaning
To preserve the finish of the unit as well as maintain
performance, it is recommended that the unit be cleaned daily.
NOTICE
Clean unit daily to avoid malfunctions and maintain
sanitary operation.
Use non-abrasive cleaners and cloths only. Abrasive
cleaners and cloths could scratch finish of unit, marring its
appearance and making it susceptible to soil accumulation.
IMPORTANT—DO NOT use paper towel or glass cleaner
to clean plastic surfaces such as sneeze guards and
flip-up doors. Paper towel and glass cleaner may scratch
the material. Wipe off plastic surfaces using a soft, clean,
water-dampened cloth.
Form No. HXMCEM1-0417
1. Turn off the unit, unplug the power cord, and allow the unit
to cool.
2. Remove and discard any remaining food product.
3. Swing open the glass side panels for easy access to the
entire shelf for cleaning.
NOTE: The glass side panels are held in place magnetically.
4. Remove and clean the product divider rods and channel
dividers.
• Lift the product divider rods straight up and out of the
channel dividers.
• The channel dividers are held in place by magnets
positioned along the front edge and back edge of the
shelf. To remove a channel divider, pull the divider away
from the edge.
Glass Side Panel
swung open.
Cleaning a Heated Merchandiser
5. Wipe down all exterior and interior surfaces using a non-
abrasive, damp cloth (a non-abrasive cleaner may be used
for difficult stains).
6. Wipe dry all surfaces using a non-abrasive, dry cloth.
7. Clean the glass side panels using a standard glass cleaner.
8. Clean the plastic sneeze guards and flip-up doors (if
equipped) using soft cleaning cloths, mild soap, and water,
if equipped. NOTICE: Do not use paper towel or glass
cleaner on plastic surfaces—scratching may occur.
11
MAINTENANCE
Channel Divider
Product
Divider Rod