Powersmart DB2603 Manual De Instrucciones página 9

When batteries become fully charged, unplug the charger from the power supply and remove the battery

pack.
WARNING: When transporting or servicing unit, always remove the battery.
WARNING: Some dust created by power sanding, sawing, grinding, drilling and other
construction activities contains chemicals known to the state of California to cause cancer, birth
defects or other reproductive harm. Some examples of these chemicals are:
Lead from lead-based paints,

Crystalline silica from bricks and cement and other masonry products, and

Arsenic and chromium from chemically-treated lumber.

Your risk from these exposures varies, depending on how often you do this type of work. To reduce your

exposure to these chemical: work in a well ventilated area, and work with approved safety equipment, such
as those dust masks that are specially designed to filter out microscopic particles.
SERVICE
Tool service must be performed only by qualified repair personnel. Service or maintenance performed by

unqualified personnel could result in a risk of injury.
When servicing a tool, use only identical replacement parts. Follow instructions in the Maintenance

section of this manual. Use of unauthorized parts or failure to follow Maintenance Instructions may create
a risk of electric shock or injury.
SPECIFIC SAFETY RULES FOR STRING TRIMMER
Only operate trimmer in daylight or good artificial light.

When being used as an Edger, stones, pieces of metal and other objects can be thrown out at high speed by

the line. The tool and guard are designed to reduce the danger. However, the following special
precautions should be taken: MAKE SURE that other persons and pets are at least 100 feet (30m) away.
Use only the manufacturer's 0.065 in. diameter replacement line in the cutting head. Do not use any other

cutting attachment, for example, metal wire, rope, or the like. To install any other brand of cutting head to
this string trimmer can result in serious personal injury.
Never operate unit without the grass deflector in place and in good condition.

Check damaged parts. Before further use of the tool, a guard or other part that is damaged should be

carefully checked to determine that it will operate properly and perform its intended function. Check for
alignment of moving parts, binding of moving parts, breakage of parts, mounting and any other
conditions that may affect its operation. A guard or other part that is damaged must be properly repaired
or replaced by an authorized service center to avoid risk of personal injury.
Never use blades, flailing devices, wire, or rope. Unit is designed for string trimmer use only. Use of any

other accessories or attachments will increase the risk of injury.
Keep the air vents clean and free of debris to avoid overheating the motor. Clean after each use.

Stop the unit and disconnect the power source when not in use. Carry the unit with the motor stopped.

Do not use the string trimmer with any type of accessory or attachment. Such usage might be hazardous.

Risk of cut. Keep hands away from the line. Keep both hands on handles when power is on.

Do not attempt to remove cut material or hold material to be cut when lines are moving. Make sure

trimmer switch is off when clearing jammed material from guard. Do not grasp the guard or lines when
picking up or holding the trimmer.
Do not force trimmer. It will do the job better and with less likelihood of a risk of injury at the rate for

which it was designed.
When not in use, the string trimmer should be stored indoors in a dry and high or locked-up place, out of

reach of children.
9