Hilti BX 3 Manual De Instrucciones Original página 19

▶ Do not store batteries on the charger. Always remove the battery from the charger when the charging
operation has completed.
▶ Never leave batteries in direct sunlight, on sources of heat, or behind glass.
▶ Store the product and batteries where they cannot be accessed by children or unauthorized persons.
▶ Prior to each use and before and after prolonged storage, check the product and the batteries for
damage.
9 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
Trouble or fault
The spring element is not ten-
sioned; no status indication.
There is a delay before the
spring mechanism is ten-
sioned, the status indicator
flashes blue and a signal tone
is emitted simultaneously; the
status indicator then lights
blue for 6 minutes.
The spring element is not ten-
sioned, the status indicator
flashes green and 1 battery
charge status LED flashes.
The spring element is not re-
tensioned, the status indica-
tor flashes green and 4 bat-
tery charge status LEDs flash.
The spring element is not ten-
sioned and the status indica-
tor flashes red.
The spring element is not ten-
sioned and the status indica-
tor lights red.
The fastener guide cannot
be pressed in and the status
indicator lights green.
The fastener guide is jammed
in the pressed-in state.
10 Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
Most of the materials from which Hilti products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti sales representative for further information.
*2180112*
Possible cause
The battery is empty.
The battery is not fitted correctly.
The magazine is empty.
The battery is empty.
Battery temperature too low.
The fastening tool has overheated.
The fastener guide is not fitted
correctly.
System fault.
The magazine is empty.
The nail pusher is jammed.
Nail jammed in the fastener guide.
Dirt between the fastener guide
and the nosepiece.
2180112
Action to be taken
▶ Change the battery.
▶ Fit the battery. → page 8
▶ Load the magazine. → page 9
▶ Change the battery.
▶ Allow the battery to warm up
slowly to room temperature.
▶ Allow the fastening tool to cool
down.
▶ Insert the fastener guide.
→ page 9
▶ Contact Hilti Service.
▶ Load the magazine. → page 9
▶ Remove the nail strips from
the magazine and clean the
magazine.
▶ Release the jammed nail.
→ page 11
▶ Clean the inside of the nose-
piece. → page 12
English 13