Carat P Serie Instrucciones página 86

TROUBLESHOOTING TABLE
Error message / error
When switched on, the
machine does not start
The machine does
not provide sufficient
performance
Low or no cooling water feed
Motor does not start
Diamond blade wobbles
Segments are coming off
86
Possible cause Troubleshooting
Mains plug is loose Check proper connection to
mains
Mains plug is defective Check the mains plug
for operability, replace if
necessary
Loose connection in the Have the entire electric
electric system system of the machine
checked
The drive motor is Have the drive motor
defective checked, replace if necessary
The main switch is Have the main switch
defective checked, replace if
necessary.
The mains plug is too long, Observe the prescribed
cord reel is wound up length of the mains plug .
Unwind the cable cord
Capacity of the local mains Pay attention to and observe
is insufficient the ma chine connection data
The drive motor does not Have the drive motor
maintain the rotation checked, replace if necessary
speed
The water pump sucks air Fill the tank with water;
swivel the pump with the
suction side downwards
Hose are clogged Clean the hoses
Hoses bent Check hose layout
A hose is leaky or Replace or re-attach the hose
detached properly
The water pump wheel or Clean the pump wheel or
strainer is polluted strainer
Water pump does not Have the electric supply line
function checked, replace if necessary
Mains plug is not properly Check the mains plug for
plugged. proper connection
A fuse at the construction Check fuses
site distribution board has
tripped
Blade tension is poor Return the diamond blade
Overheating, cooling is Check cooling water line
poor
Segments are soldering on
Personnel
Operating personnel
Qualified electricians
Operating personnel
Qualified electricians
Operating personnel
Qualified electricians
Operating personnel
Manufacturer
Operating personnel
Manufacturer