GE DPXQ473ET Manual De Instrucciones página 16

Problem Possible Causes What to Do
Overdrying ° TI T a fabric softener.
° Adjust controls for less drying.
No fabric softener was used • T U a fabric softener.
Synthetics, permanent press ° T U a fabric softener.
and blends can cause static
Improper sorting
Separate heax T items from lightweight items
(generally, a well-sorted washer load is a
well-sorted duer load).
Large loads of heavy items • Large, heax T loads contain more moisture
(like beach towels) and take longer to dry. Separate large, hea W
items into smaller loads to speed drying time.
Controls improperly set • Match control settings to the load you
are drying.
Lint filter is full • Clean lint filter before every load.
Improper or obstructed • Check installation instructions for proper
ducting ducting/venting.
Blown fuses or tripped
circuit breakers
Overloading/
combining loads
Underloading
Make sure ducting is clean, free of kinks
and unobstructed.
Check to see if outside wall damper
operates easily.
See the Venting the DiTer section.
Replace fuses or reset circuit breakers. Since
most &Ters use 2 fuses/breakers, make sure
both are operating.
Do not put more than one washer load in
the diTer at a time.
If you are &Ting only one or two items,
add a few items to ensure proper tumbling.
17