Cleaning And Maintenance - BORETTI B400 Manual De Instrucciones

AFTER PREPARING YOUR BEVERAGES WITH MILK
Once you are done preparing your beverage with milk, you can either
store the unit's milk reservoir directly in the refrigerator (ready to be
used for the next time) or dispose of the leftover milk.
« DESCALING
With the milk reservoir placed in position the appliance will remind the user to perform
descaling in a way of six indicators quickly flashing alternatley. At that time, the user shall
fill the water tank with 600ml clean water and dedicated descaler, then press Espresso and
Latte buttons simultaneously and the appliance enter into descaling condition automatically,
then the six indicators slowly flash alternatly. After working for about 30min the six indicators
quickly flash alternatly and then the user shall empty the water tank and refill it with 600ml
clean water. After it, press the Espresso and Latte buttons simultaneously again and the
appliance continous to perform descaling, at that time, the six indicators slowly flash
alternalty. After working for about 30min, the appliance stops working and goes back to the
standby condition. Empty the water reservoir and milk reservoir and fill the water reservoir
with clean water for usage.
« CLEANING AND MAINTENANCE
Cleaning the milk reservoir and frothing tube
Even though you can store the milk reservoir with left over milk in the refrigerator, it is
important to clean the reservoir and frothing tube regularly to avoid clogging and building
residues. In order to clean the milk reservoir, please follow the instructions listed below:
1. Remove the milk reservoir from the unit
2. Remove the lid of the reservoir.
3. Pour any milk left and rinse and wash the milk reservoir and its lid thoroughly with warm
soapy water. Rinse and dry well. Do not use abrasive cleaners and scouring pads, as they
will scratch the finish. The milk reservoir is also dishwasher safe (top rack). Do not place
the lid of the milk reservoir and the drip tray in the dishwasher.
Note: Also remove the suction tube and dispensing tube for better cleaning.
4. Place a large empty cup under the frothing tube.
5. Press and hold the Latte/clean button for 3 seconds and then
release it. The unit will start releasing steam through the frothing
tube, let it run for a few seconds until you don't see any milk in
cup. When done press the Latte/ clean button once to stop the
process.
6. Dispose any water left on the milk reservoir and place it back in
the unit.
Note: For removing the milk reservoir, you should raise it up a little
on the front, then pull it out.
61
EN