Dometic DTB01 Instrucciones De Montaje Y De Uso página 15

2. Place the fastening frame on the wall chosen for installation and marks the locations of the holes for the fixing
screws (diameter 3 mm) and hole for the communication cable pass through (minimum diameter 7.2 mm)
3. Drill the holes and screw the fastening frame to the wall, using the screws provided. Ensure that they do not pro-
trude once screwed in.
Connecting the display
1. Feed the communication cable (white connector) through the hole previously made and insert it onto the elec-
tronic board of the display.
Fig.  on page 4
2. Insert the communication connector to the display board.
3. Connect the display to an N-BUS or CI-BUS device.
4. Slide the display cover on the fastening frame.
9 Before first use
The display allows you to set up and control all networked N-BUS or CI-BUS devices. When the display is started for
the first time, it searches for all connected devices and displays the setup menus of all devices in succession. After the
start-up, set the required data by moving through the various screens with the selection buttons. The setup can also
be completed later.
ON/OFF
1. Press the
Fig.  on page 4
ON/OFF
After pressing the
2. Set the required data by moving through the sequence of screens with the selection buttons.
Fig.  on page 5
10 Operation
Using the device
When starting the display, only the menus for the connected devices are shown in succession.
When operating the device, the display illumination is switched on and remains activated for 3 minutes. If there is
no further operation within this time, the lighting switches off automatically. The display continues to show the same
content as before with lighting. Pressing any button activates the display illumination. Only the second press of a but-
ton performs the actual function of the button.
Displaying data (for the connected devices only)
1.
Press the button to display the battery screen of one or more batteries.
Fig.  on page 5
The charging values of the battery are displayed.
button.
button, the loading screen is displayed and the network is initialized.
Fig.  on page 6
EN
13