GE GXCC01D Manual Del Propietário página 6

Care and cleaning of the dispenser.
Draining the Dispenser
The dispenser should be drained before cleaning the tanks and before leaving fbr long vacaOons or absences.
Storage models
(rear of dispenser)
Drain
outlet cap
Drain cover and
retaining clip ¢_ _\---_ /
!
Countertop models
(bottom of dispenser)
Storage Models
i. Set b(_th power switches (on the back of the dispense_;
if equipped) in file 0 (off) position and
unplug
file dispenser
2. Remove file water bottle flom file dispenser
3. Put a container fllat will withstand hot water under file hot
water tap. Press the hot dispenser button until the water
is cool (about 1 quart). Add wamr to the cold water reservoir
(on top where the bottle supplies water) as needed.
4. Dispense wamr flom both buttons into cont;dner(s)
until
no more water can be dispensed (about 1 quart of water
still remains in the dispenser).
5. Place a large bucket beneath the drain oudet on the rear
of the dispenser
& Using a Phillips screwdrke_; loosen the screws on the bracket
covering the drain outlet cap. Rotate the bracket out
of the way to allow access to the cap.
7. Remove the cap and silicon stopper flom the drain outlet
and and allow wamr to drain. After draining, replace the
stopper and cap.
8. Rotate the bracket back into place and tighten screws.
Make sure to install a full bottle and dispense wamr flom
the hot water tap before plugging in and turning on the
dispenser (see
Loadingthe Dispenser).
Countertop Models
1. Set both power switches (on the back of the dispensei,
if equipped) in the 0 (O#)position and unplug
the dispenser
2. Remove the water bottle flom the dispenser
3. Put a container that will withstand hot water under the hot
water tap. Press the hot dispenser button until the water
is cool (about 1 quart). Add wamr to the cold water reservoir
(on top where the bottle supplies water) as needed.
4. Dispense wamr flom both buttons into container(s)
until
no more water can be dispensed (about 1 quart of water
still remains in the dispenser).
WARNIN& ti the d ispenser caret, lly. itweighs
approximately 40 Ibs (18kg). Avoidaccidentallypressing
the dispenser buttons while lifting or carrying.
5. Place the dispenser over a sink with 3 feet on the counter
Hold or secure the dispenser steady while removing the
retaining clip and drain cover Remove the retaining clip
and drain cover flom the drain outlet, making sure not
to damage the drain cover Allow water to drain.
6. Af*er
draining,
replacethedraincover and retaining clip.
Make sure to install a full bottle and dispense water flom
file hot water tap before plugging in and turning on file
dispenser (see
Loadingthe Dispenser).
6